Switching On And Off; Working With The Lawnmower - PRO-PULSE 02255002 Manuel De L'utilisateur

ASSEMBLY
1. Reach under the body of the lawn mower (6) and pull the wheel axle towards you.
2. While pulled, the wheel axle can be moved up or dowm to any of the three cutting
heights.
3. If the height is correct, just let go of the spring-loaded wheel axle to let it snap back
into working position.
A higher cut height should be selected for the first cut of the season.
Observe the noise protection and local regulations.

Switching On and Off

1. Insert the power cable plug into the socket (9) on the curved handle (1).
2. Connect the mower to the power supply.
3. Before switching on, ensure that the mower is not in contact with any
objects.
4. To swith on, press the release button (10) on the handle at the same
time as pressing the start lever (11). Release the release button (10).
5. To switch off, release the start lever (11).
WARNING:
After switching off the equipment, the blade continues to turn
for several seconds. Do not touch the moving blade. There is a risk of injury.

Working with the lawnmower

Regular mowing encourages increased foliation of the grass and kills off weeds at the
same time.
Therefore, not only does each mowing increase the density of the lawn, it also produces
an evenly resilient lawn.
The first cut is to be made in around April, at a growth height of 2.75" - 3.15". In the
main growing period, the lawn is to be mowed at least once a week.
Start mowing near the electric plug and work away from the power source.
Always keep the extension cable behind you and when you turn, move it to
the side that has already been mowed.
Push the mower at awalking pace, in tracks that are as even as possible.
For gap-free mowing, the tracks should always overlap by a few centimetres.
Adjust the cutting height according to the grass height, so the equipment is
not overloaded. Otherwise, the motor may be damaged.
On slopes, always work across the slop. Take particular care when going
backwards and pulling the equipment.
Clean the equipment after each use, as described in the chapter on
" Cleaning,Maintenance and Storage ".
Switch off the equipment after work and in order to transport it, disconnect
the plug and wait until the blade stops. There is a risk of injury.
32 ME1013L
!