Gardeo GMTBE1506W Traduction Des Instructions D'origine page 48

Mounting the grip rod « D »
Make sure during assembly
that the device cable is not
pinched and has enough
Mounting the middle handle bar
1. Position the curved end of the middle
handle bar (9) between the lower handle bar
(11).
2. Attach the middle handle bar with the
screws (10), washers (10b) and clamping
levers (10) supplied.
3. Turn the tightening levers (10)
clockwise.
4. Lock the tightening levers (10) by pressing
them in the direction of the middle handle (9).
The tightening levers must be positioned
against the handle such that tightening can be
carried out with medium force.
Working position/
transport position « E »
The wheels can be adjusted in
2 ways:
1 Transport position: The wheels are
folded down, the device is mobile.
2 Working position: The wheels are
folded up. The device is ready for use.
Réglage de la position de travail :
Setting the working position »F »
1. Tighten the wheel adjustment ring (12) and
fold the wheels (14) upwards.
2. Release the wheel adjustment
(12). The locking pin snaps into the upper hole
(11a) on the lower handle (11).
Setting the transport position "F"
3. Tighten the wheel adjustment ring (12) and
fold the wheels (14) downwards.
4. Release the wheel adjustment (12). The
locking pin snaps into the lower hole (11a) on
the lower handle (11).
play.
OPERATION
If this fails, continue to turn the tightening lever
clockwise, or loosen it by turning counter
clockwise (see small image)
Mounting the upper handle:
5. Position the curved end of the upper handle
(6) between the middle handle (9).
6. Attach the upper handle (6) with the screws
(7a), washers (7b) and clamping levers (10)
supplied.
7. Lock the clamping levers as described
under 3. and 4.
Clipping in cable clamps:
8. Clip in the cable clamps (19) to the middle
handle (9) and use these to fix device cable (18)
in position.
If you release the clamping levers (7/10),
you can fold down the upper handle (6) and
the middle handle (9) to store the
lawnmower.
Switching on and off « G »
Note: Before switching the
tool on, make sure that the
tool is not touching any other
objects and hold it firmly in
1. Plug the tool into the extension cable.
2. For cable strain relief, form a loop in the end
of the extension cable and hang it into the cable
relief (20).
3. Connect the equipment to the mains power
supply.
4. To switch on, press the release button (2)
on the handle then the starting lever (3).
Release the release button (2).
The cutting blades start to rotate and dig into
the ground.
5. To switch off, release the starting
lever (3).
both hands.