Functional Description - Gardeo GMTBE1506W Traduction Des Instructions D'origine

Your hand-operated garden tiller is equipped with a maintenance free electric
The tool is fitted with six rotating tine wheels that automatically dig themselves into the ground.
Please refer to the following descriptions for the function of the controls.
1 Control element
2 Release button
3 Starting lever
4 Right grip
5 Left grip
6 Upper grip handle
7 2 tightening levers for fastening
the upper grip handle
8 Mains cable
9 Middle handle bar
10 2 tightening levers for fastening
Scope of delivery
Carefully remove the tool from the pack-
aging and check that the following parts
are complete:
- Motor housing with cutting blade and
control element
- Upper grip handle
- Middle handle bar
- Mounting accessories for handle mount-
ing
(4 tightening levers, 4 washers,
4 screws)
- 2 wheels
- Mounting accessories for wheel mount-
ing
(2 hubcaps, 2 screws, 2 washers,
2 spring washers)
- 2 cable clamps
- User manual

FUNCTIONAL DESCRIPTION

motor and a gearbox with sump lubrication.
The steel frame can be folded to aid storage.
FUNCTIONAL PARTS « A »
The major functional parts are shown on page 2 and 3.
ASSEMBLY INSTRUCTIONS
Always disconnect
the tool from the
mains before
conducting any work
on it.
the middle handle
11 Bottom handle
12 Wheel adjustment ring
13 Protective cover
14 2 wheels
15 Cutting blade
16 Motor housing
17 Carrying handle
18 Device cable
19 2 cable clamps
20 Cable relief
Fitting the wheels « B »
1. Put a wheel (14) on the wheel axle (14a) so
that the hub cap is facing outwards.
2. Screw the wheel (14) on to the device. To
do this, use the enclosed screw (14c), spring
washer (14d) and standard washer (14e).
3. Press the end cap (14b) on the wheel.
4. Mount the second wheel in the same way.
Mount the control element « C »
1. If necessary, loosen the 4 screws (1a) on
the control element (1) and remove the handle
cover (1b).
2. Press the end of the upper handle bar (6)
into the control element (1) so that the holes in
the upper handle bar fit into the pinson the
control element (1). Make sure that the cable of
the device (18) is not twisted.
3. Put on the handle bar cover (1b) and screw
it tight with the 4 screws (1a).