Adjustment; Installing The Led Light - Tetra AquaArt Explorer Line 30 l Notice D'utilisation

English translation of the original German instructions
ATTENTION!
Incorrect cleaning may damage the aquarium or
poison the tank contents.
 Never use any hard, pointed or sharp objects
for cleaning purposes.
 Use soft cloths or sponges.
 Use only clean water or special aquarium
cleaning products for cleaning purposes.
These are available from your stockist.
 Particularly the corners of the tank must be
cleaned carefully to prevent damage to the
glued joints of the glass walls.
 Clean any impurities out of the tank.
 Add warm tap water at a temperature of approx.
25 °C to the tank.
 Check the tank for leaks.
 If the aquarium is leaking, empty it and return the
tank to your stockist for a replacement.

Adjustment

Installing the LED light

 Follow the instructions in the attached instructions
to install the LED light.
 Install the LED light in the position provided for it
(Figure A).
Installing the filter in the Explorer
Line 30 l
The AquaArt Explorer Line 30 l Crayfish and the
AquaArt Explorer Line 30 l Goldfish are supplied with
the EasyCrystal Filter 250.
 Remove the aquarium lid.
 Select a position to install the filter on the inside
of the tank which is not curved.
 Ensure that you keep the filter the required
distances from the base and from equipment in the
aquarium.
The required distances are listed in the attached
instructions for the filter.
14
 Ensure that you satisfy the requirements relating to
the water level set out in the instructions for the
filter.
 Secure the filter vertically on the inside of the tank
as shown in the instructions for the filter.
The cable guides and optional positions for electrical
devices in the aquarium lid are closed with covers
upon delivery. The covers can be removed by hand or
with a pair of pliers.
ATTENTION!
The aquarium lid may be damaged if too much
force is used to remove a cover.
 Score the edges of the cover with a sharp
knife before you remove the cover.
 Remove the cover carefully.
 If the filter is installed level with the aquarium lid,
carefully remove the cover from the corresponding
optional position in the aquarium lid (Figures B and
C).
 If the filter is installed below the aquarium lid,
carefully remove the cover from a cable guide for
the mains cable (Figures B and C).
 If the cable guides or optional positions have sharp
edges, smooth them with a small file.
 Route the power cable upwards and out of the
aquarium.
 Follow the attached instructions for the filter to
complete the remainder of the installation work.
Installing the filter box and heating
element in the Explorer Line 60 l
The AquaArt Explorer Line 60 l is supplied with the
EasyCrystal FilterBox 300. This contains the filter. In
addition it houses the supplied heating element.