Heta Scan-Line 900 Mode D'emploi page 7

Positioning the rotating base
Place the rotating base on the floor. Turn it to the
neutral position. See Fig. 4. Position the stove with the
door facing in the same direction as the neutral line.
Check that the safety distances for the stove are met
when the stove is turned all the way to the end stops.
Please refer to the instructions for the use of your
stove.
Fig. 4
Figure 4
Neutral-
line
Hole in ceiling for the flue
After positioning the rotating base in accordance with the
pivot centre, mark the hole for the flue on the ceiling. See
Fig. 4.
Fitting the turn spigot
Remove the factory fitted spigot. Fig. 5. Replace this
with the turn spigot with ball bearings that is supplied
with the rotating base. Fig. 6.
Figure 5
Figure 6
90°
Pivot
centre
Placing the stove
on the rotating base.
Unscrew the centre screw. See Fig. 2.
Use the transport case as protection to prevent scratching
the rotating base. Place the box approx. 15 cm from the rear
edge of the rotating base. Then "walk" the stove up onto the
rotating base. See Fig. 7.
Scan-Line 900 see page 16
Figure 7
Figure 8
Centre screw
Place the stove approximately in position, so that it is cen-
tred on the rotating base. Then tilt the stove backwards and
pull the transport packaging out.
Position the stove over the centre and refit the centre screw.
See Fig. 8.
7
EN