Key Defi Nition; Manual Mode; Alarm Operation - Konig Computer CMP-MULTIPAN50 Mode D'emploi

6. FP-01 Operation
6.1 Key Defi nition
KEY
+
-
Mode
Set (press once)
Set (press 2 seconds)
6.2 Operation

6.2.1 Manual Mode

Press "mode" to switch between fan1 temp1 / fan2 temp2 / fan3
temp3.
Press "+" or "-" to adjust the fan speed.
Setting
Press "SET" for 2 seconds to enter setting mode.
Press "+" or "-" to set alarm fan speed [500 ~ 2000 RPM (step 100
RPM)], press "MODE" again to start setting alarm temp (Temp.
range:40-80°C at 5°C interval / 104-176°F at 9°F interval).
Press "+" or "-" to set alarm temp.
Continue the above procedure until all 3 channels are set.
Press "SET" for 2 seconds to return to normal mode; OR
Auto Mode (continued from Setting)
Press "MODE" again and the word "AUTO" will show on the display.
Press "SET" for 2 seconds to return to normal mode.
Note: You can not control the fan RPM in auto mode.
Sensor temp. 45
Sensor temp. 55
Sensor temp. 65

6.2.2 Alarm operation

Alarm buzzer will sound if:
- fan speed is either lower than the set rpm or fail to work. The display
will show "----".
- detected temperature is higher than the set alarm temp.
If thermal sensor is not installed, the display will show "----".
Defi nition
Increase fan speed
Decrease fan speed
Switching display channel
Switch between Celsius or Fahrenheit
Set alarm temp and alarm fan speed
o o
C / 113 F for 7V
o C / 131 o F for 10V
o C / 149 o F for 12V
8