Technical Data; Cleaning And Maintenance - METAWOOD MTTM350-200 Traduction Des Instructions D'origine

The spark guard protects your
eyes and hands from sparks
flying from the workpiece.
Therefore, always use the spark
ADJUSTING THE WORKPIECE SUPPORTS
You must regularly adjust the workpiece
supports in order to compensate the wear of
the grinding wheels.
Loosen the adjusting screw (7).
Adjust the distance between the
workpiece support (6) and the grinding wheel (2) to
the smallest possible value, with a maximum
of 2 mm.
Tighten the adjusting screw.
INSTRUCTIONS FOR USE
Before switching on the machine, check if
all screws and nuts are tight and if the grinding
wheel can rotate freely.
Always grind on the front part of the grinding
wheel. Never overcharge the machine, causing the
grinding wheel to come to a halt.
The machine is not intended for permanent use.
Make sure that the machine is not overheated. After
using the machine for 30 minutes, let it cool down
to ambient temperature.
SWITCHING ON AND OFF (FIG. A)
To switch the machine on, set the on/off
switch (1) to 'I'.
To switch the machine off, set the on/off
switch (1) to '0'.

CLEANING AND MAINTENANCE

performing any work on
the equipment, pull the
Service
§ Only qualified specialist personnel and original
replacement parts should be used for repairs. This
will ensure that your device remains safe.
Cleaning
§ Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt
does not come off use a soft cloth
moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
guard.
Attention! Before
power plug.

TECHNICAL DATA

Mains voltage V
Mains frequency Hz
Power input W
Speed min-1
Max. thickness grinding wheel mm
Diameter grinding wheel mm
Wheel bore mm
Weight kg
Level of sound pressure measured
according to EN 292-2 :
Acoustic pressure level
LpA 63 dB(A) K = 3 dB(A)
Acoustic power level
LwA 76 dB(A) K =3 dB(A)
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard. : < 2.5 m/s²
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our after-
sales service department.
_ If replacing the power cord is necessary, it
should be done by the manufacturer or his agent
to avoid a hazard.
STORAGE
_ Thoroughly clean the whole machine and its
accessories.
_ Store it out of the reach of children, in a stable and
secure position, in a cool and dry place, avoid too
high and too low temperatures.
_ Protect it from exposure to direct sunlight. Keep it
in the dark, if possible.
_ Don't keep it in plastic bags to avoid humidity
build-up.
230
50
350
2950
16
200
20
12
ATTENTION !
must be worn.