Quick Reference - Philips SBC SC 367 Mode D'emploi

1. GENERAL
CONTENTS
1. GENERAL .................................................4

2. QUICK REFERENCE .................................4

3. POWER SUPPLY ...................................4-5
4. OPERATION ..........................................5-7
TECHNICAL SPECIFICATIONS.........42-43
ILLUSTRATIONS......................................3
2. QUICK REFERENCE
1. Connect one of the enclosed mains adapters to the 'baby unit'
(transmitter) and the other to the 'parent unit' (receiver) recharging base
(fig. 2) .
2. Set the transmitter to VOICE mode (fig. 1.6) and place it near the baby's
bed.
3. Place the receiver in the recharging base (fig. 2) .
4. Switch the receiver on to an acceptable sound level (fig. 1.4) .
– Every time sound is detected from or near the baby, it is transmitted to
the parent's unit.
5. Adjust the sound level on the receiver as required.
3. POWER SUPPLY
Mains power supply
• Check that the mains voltage as indicated
on the mains adapter corresponds to your
local mains voltage. If it does not, consult
your dealer or our service organisation.
• Connect a mains adapter to the transmitter
as indicated in fig. 2 .
• Place the receiver inside the recharging
base and connect a mains adapter as
indicated in fig. 2 .
– If the mains power adapter is connected
correctly, the red CHARGE LED on the
recharging base lights up.
4
INTRODUCTION
Congratulations! You have just purchased a
truly cordless Babysitter (SBC SC367) that
enables you to monitor your child from
wherever you are in and around your house.
The Babysitter has been tested to meet all
necessary regulations and standards, and
features a rechargeable battery back-up that
guarantees operation at all times.
Note: While the Babysitter is intended as an
aid, it is not a replacement for real
parent supervision and should not be
used as such.
QUICK REFERENCE
Battery power supply
Transmitter (batteries not enclosed)
• Install batteries inside transmitter as
indicated in fig. 3 for cordless transmitter
operation.
Receiver (batteries enclosed)
– Rechargeable batteries are already installed
inside the receiver.
• For maximum battery life make sure that the
batteries inside the receiver are totally
discharged and recharged on a regular basis.
SBC367page 4