Installing The Remote Control; Filling The Water Tank; Maintenance - Duux Beam Ultrasonic Manuel D'utilisation

Use
Installing the device
Unpack the device and remove the packing
1
materials from the device. Store the packing
materials for possible future transportation.
Plug de power cord in a wall outlet. You will
2
hear a beep and the power indicator will blink.
Press the power button to switch on the device
3
and the display will light up.

Installing the remote control

1 Remove the screw from the lid
2 Place the batteries according to the
instructions inside the hatch with the correct
polarity
Close the lid and screw
3
Please note:
• Only use 2x AAA LR03 1.5V batteries
• Non-rechargeable batteries are not to be
recharged
• Different types of batteries or new and used
batteries are not to be mixed
• Exhausted batteries are to be removed from the
remote controller and safely disposed of
• If the remote controller is to be stored unused
for a long period, the batteries should be
removed
• The supply terminals are not to be short-
circuited.
6

Filling the water tank

Note: Always remove the plug when filling the
water tank. Preferably use clean tap- or distilled
water to prevent bacteria and scale inside the water
tank.
Warning: Only fill with cold or lukewarm water.
Hot or boiling water will damage the device.
Please add water to the water tank before using
the device according to the steps below:
Remove the power plug and take off the lid on
1
the top side;
Fill the water tank with water using a
2
watering can or container (do not exceed the
transparent water inlet cover)
Place back the top cover and make sure it fits
3
properly. You may now switch on the device.
!
Please fill here
Note: When using the device for the first time,
the water may have a slight smell and discoloration.
This is normal and not harmful for your health.
Tip: We recommend to use distilled water to
prevent the growth of scale inside the water tank.

3. Maintenance

Important: Be sure to remove the power plug
from the outlet before carrying out maintenance.
Important: Do not soak or immerse the power
plug or the device in water.
Important: We recommend daily maintenance
to prevent the growth of bacteria and scale inside
the water tank.
Water replacement
In order to maintain the best performance of the
humidifier, the water in the water tank and the
water tank itself should be cleaned regularly;
Cleaning
Please use a soft cloth to wipe the dust on the
•
body; If the surface is too dirty, it is better to wipe
it clean with a damped cloth mixed with neutral
detergent.
Do not use chemical solvents, gasoline, polishing
•
powder, etc. to clean the surface of the device.
Do not place the device or any of it's parts in the
dishwasher to clean. It is best to clean it with clean
water.
Please use a soft cloth to clean the parts (see
•
image) regularly. If the regular cleaning can't
remove the scale on the inside of the water tank,
mix some lemon vinegar with lukewarm water
(water and lemon vinegar ratio 10ml:1g) Pour
everything into a large container and let it soak for
5 minutes. Then gently scrub the scale surface with
a soft brush until the scale is removed.
7