Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Butler 3011/3011C
Caution : Do not forget your personal PIN code. If you do, you have to restore the
default settings (reset – see section 4.30).
4.23 SUBSCRIBING A HANDSET TO A B24XX, 28XX, 29XX, 30XX, 32XX, 40XX
In order to be able to make and receive telephone calls, a new handset has to be subscribed
to the base unit. You can subscribe 5 handsets to one base unit. By default, each handset is
subscribed as handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if: !!!
•
the handset subscription has been removed from the base unit (e.g. for reinitialisation)
•
you want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a B30XX handset and base unit!!
Keep the Paging key
indicator
on the base unit begins to blink rapidly. The Line/Charge indicator
blink rapidly for one minute. During this minute, the base unit is in subscribing mode and you
must do the following to subscribe the handset:
•
Press the Programming key
•
Press the Up or Down key
•
Press the Programming key
•
'BASE _' appears on the display.
•
Enter a number of the base unit you would like to subscribe the handset to (1-4).
Use the number keypad.
Note: Each handset can be subscribed to 4 different DECT base units. Each base
unit is assigned a number from 1 to 4 in the handset. When you subscribe a new
handset, you can assign a base unit number. It is best to use '1' .
•
'SEARCHING' and the symbol
•
The RFPI code (each base unit has a unique RFPI code) appears on the display and a
signal sounds when the handset has found the base unit.
•
Press the Programming key
•
'PIN' appears on the display.
•
Enter the 4-digit PIN code of the base unit in (default PIN code is '0000'). Use the number
keypad.
•
Press the Programming key
•
The handset is subscribed to the base unit.
4.24 SUBSCRIBING BUTLER 3011 HANDSET ON ANOTHER BASE (OTHER
BRAND/MODEL)
Put the base in subscription mode (see manual of the base). If the base is in subscribing
mode, you have to do the following to subscribe the handset:
•
Press the Programming key
•
Press the Up or Down key
•
Press the Programming key
•
'BASE _' appears on the display.
•
Enter a number for the base unit to which you would like to subscribe the handset (1-4).
18
on the base unit pressed for 10 seconds until The Line/Charge
.
repeatedly until 'BASE SUB' appears on the display.
.
appears on the display.
.
.
.
repeatedly until 'BASE SUB' appears on the display.
.
will
Butler 3011/3011C
Publicité
Table des Matières
