in-lite WEDGE DARK Manuel D'utilisation page 7

EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
When mounting the fixture you can choose to use the transparant or
the diffuse lens.
General Installation Guideline
During installation, make sure that all components are easily
accessible for replacement.
Step 1
Remove the Torx screw (A), (Fig. 1a). Remove the cover in the direction
of the arrow (Fig. 1b). Ensure that there is a hole of at least 13 mm / 0.5
inch Ø in the wall to lead the cable through. Make this hole at a place
where the lower half of the fixture will cover it. You can use the sup-
plied template. (Fig. 2) Attach the back of the fixture to the wall with
the screws provided (B). (Fig. 3)
Step 2
Reinstall the cover and tighten the Torx screw.
Step 3
Join the Easy-Lock connector to the main cable. (Fig. 4)
a. Clamp the cable duct on top of the main cable.
b. Place the cable duct (with the cable at the bottom) in the Easy-
Lock connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 4
Connect the main cable to the fixture by connecting the mini-
connector. (Fig. 5)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 3 and 4. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.