Workbench - Gladiator CADET Série Instructions D'assemblage

2
3
Front
Maximum Weight Limit: 500 lbs. (225 KG) Total
Cross Support
Back rail
1

Workbench

INSTRUCTIONS
CADET-6624
WARNING
Excessive Weight Hazard
Use two or more people to move
and assemble workbench.
Failure to do so can result in
back or other injury.
1. Frame Assembly
Assemble the front and back rails to the leg assemblies
using 12 bolts as shown.
Assemble the cross support to the legs using 8 bolts as
shown.
Important: Make sure the cross support is on the same
side as the back rail.
2. Top Assembly
Assemble the channel to the front of the workbench top.
First position the channel on the top as shown. Keep the
ends of the channel flush to the ends of the top.
Using the holes in the channel as a guide, drill 8 pilot
holes 1/8" dia x 1/2" deep.
Fasten the channel to the top using 8 screws as shown.
3. Final Assembly
Keep the workbench top in the same position
Center the frame on the top by making the distance form
the outside edge of the frame to the outside edge of the
the top the same distance for the two ends and the
same distance for the front and back. The front rail of
the frame and the front channel of the top must be on
the same side.
Mark the location of the 8 mounting holes.
Remove the frame and drill 8 pilot holes 1/8" dia. x 1/2"
at the marked locations.
Fasten the frame to the top using 8 screws as shown.
Assemble the 4 levelers to the legs by screwing them
completely into the hole in the bottom of each leg.
Turn the workbench over and level it by turning down
only the levelers needed to level the workbench
6 16
40192-1004