Storage Cabinet; Drawer Removal; Trim Installation - Gladiator CADET Série Instructions D'assemblage

1
.
Assemble leveler plates to bottom of
cabinet. Assemble levelers by
screwing them completely into the
holes in the plates.
3
.
To reposition the top or bottom shelf, first
remove the retaining plugs.
Remove the shelf by placing 2 hands
underneath the shelf and lifting with even
pressure.
Move the shelf to the desired location
making sure all the tabs pass completely
through the shelf locating slots.
Maximum Weight Limits
Shelves: 125 lbs. (56 KG) each
Cabinet: 500 lbs. (225 KG) total
1
3
Drawer Removal and General Maintenance
To Remove a Drawer
1. Pull the drawer all the way open then push it back to align tab with the opening
in the drawer channel.
Push the tab in with a screwdriver as shown until tab clears the stop on the
drawer channel.
Repeat on other side and remove drawer.
To reinstall the drawer, pry out the tab (apprx. ¼" (6mm)) and slide drawer
channels back into drawer channels. Firmly push drawer until it reaches the
closed position.
Maintenance
Drawer Slides should be lubricated periodically. Any good quality
household type lubricant can be used. Hardware (nuts, bolts,
screws) should be tightened periodically to maintain trouble free
operation.

Storage Cabinet

INSTRUCTIONS
CADET-7203
WARNING
Excessive Weight Hazard
Use two or more people to
move and assemble cabinet.
Failure to do so can result in
back or other injury.
2
.
Locate the cabinet in the desired
location.
Make sure the cabinet is level and
square by rotating down only the
levelers required.
2

TRIM INSTALLATION

4 16
40192-1004