Preparation; Screen Position Alignment Check (Captioning Mode); Channel And Audio Selection - Sony STW-C140GI Mode D'emploi

Preparation

Before providing customers with units,
make prepare the units as follows.
Captioning mode:
• Screen position alignment check
• Channel selection
• Language selection
Audio mode:
• Channel selection
• Audio selection
Screen Position Alignment
Check (Captioning Mode)
If the screen position alignment of the
captioning glasses is incorrect, do not use
them. Contact your dealer for service
information.
1
Connect the captioning glasses to the
receiver box, and put the glasses on.
Note
The triangular marks of the plug and
connector should be aligned.
2
Make sure that the unit is turned off.
3
While pressing and holding the SEL
button, press the POWER button to
turn the unit on.
The screen position alignment check
image appears on the glasses.
Left screen
Correct
The combined picture you see with both eyes
Right screen
4
Check that the horizontal line crosses
all the vertical lines, as shown below.
Correct
Incorrect
5
Press and hold the POWER button for
about two seconds until the POWER
indicator starts blinking in amber.
Press the POWER button again to turn
off the receiver box. The POWER
indicator goes out.

Channel and Audio Selection

Set the receiver box and the Data
Transmitter to the same channel, and select
HI (Hearing Impaired) or VI (Visually
Impaired) accordingly.
1
Make sure that the unit is turned off.
2
Press the POWER button to turn on
the receiver box.
The POWER indicator and channel
indicator start blinking.
17
GB