Proficook PC-FW 3058 Mode D'emploi page 36

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
English
36
Electrical Connection
• Ensure that the device voltage (see label) and the mains
voltage are the same.
• Set the step switch to 'OFF' and the put the plug into a
properly installed socket.
Switching On
• Move the step switch on the controller to the desired
setting.
• The relevant temperature level will illuminate and show
that the device is in operation.
• If the device has switched itself off after 90 minutes of
use, you can switch it back on my setting the step switch
to 'OFF' and then setting the desired temperature level
again.
PLEASE NOTE:
Unusual smells may occur during the first use. These are
harmless and will cease over the course of operation.
Cleaning
WARNING:
• Pull the plug out of the socket before each time you clean the
device.
• Only clean the device when it is cool. Risk of burns!
• Do not submerge the foot warmer with the step switch in water.
This could lead to an electric shock or a fire.
• Do not use any strong cleaning agents or solvents.
Please note the care instructions on the labels.
Inner Lining
1. First remove the plug from the electricity supply.
2. Take the inner lining out of the foot warmer.
3. You can wash the inner lining in the washing machine on
a delicate cycle at 40 °C.
Use a mild detergent and follow the instructions of the
manufacturer on amount of detergent.
ATTENTION:
• Please note that the inner lining may not be chemi-
cally cleaned, wrung out, dried in a tumble dryer or
ironed.
Step Switch
You can choose the following settings:
Settings
0
1
2
3
PLEASE NOTE:
You can identify the setting using the temperature level
controller.
Switching Off
• Set the step switch to 0 (off).
• Remove the plug from the electricity supply after use.
• The device will switch itself off after 90 minutes. This saves
energy and provides additional safety as the foot warmer
is never used without supervision.
ATTENTION:
• Please note that high stress is placed on the inner
lining by frequent washing. The inner lining should
be washed in a washing machine a maximum of five
times during its service life. We therefore recom-
mend that you wash the device exclusively by hand.
4. Immediately after washing, pull the inner lining into its
original shape and leave it to dry lying flat over a washing
stand.
ATTENTION:
• Do not use any clothes pegs or similar to attach
the inner lining of the foot warmer to the washing
stand. Otherwise this may damage the inner lining.
Function
Off
Low. Light heat.
Medium
High

Publicité

Table des Matières
loading

Table des Matières