Hkoenig Baby Boo BB80 Manuel D'utilisation page 14

CARE AND CLEANING
QUICK CLEAN:
After each use, simply half fill the jug with warm water and add a drop
1.
or two of dishwashing liquid, fit the lid onto the jug and run the motor
using the "PULSE" button for 30 seconds. The blender uses its own
power to clean both the jug and the blade system.
Rinse and allow to thoroughly dry.
2.
FOR MORE THOROUGH CLEANING:
Before cleaning, switch off and disconnect from the wall power outlet.
1.
Remove the jug from the motor unit.
2.
Carefully lift the blade out of the jug by the plastic centre.
3.
CAUTION: Blades are sharp, handle carefully.
Rinse the jug with water.
4.
With the lid removed, sit the jug upside down on a flat bench or table.
5.
If the jug is assembled, disassemble it using the following instructions.
6.
Remove the drive shaft from the base of the jug by turning the drive
7.
shaft clockwise and lifting it out.
Rinse the drive shaft with warm water and wipe clean. Be sure not to
8.
misplace the driveshaft gasket while cleaning. Rinse and air dry.
IMPORTANT: Do not place the drive shaft or drive shaft gasket in the
dishwasher.
Wash the jug in warm soapy water.
9.
IMPORTANT: Do not place the jug in the dishwasher.
Dishwasher safe parts are labelled on page 4 with a
10.
Wash the lid and blade in warm soapy water. Alternatively, these parts
11.
can be washed in the dishwasher. Place on the top rack only.
CAUTION: Be sure the drive shaft is removed from the jug when
washing.
The water tank will be hot immediately after use. Allow it to cool before
12.
lifting it off the motor unit. Empty the water tank after each use and
allow it to dry before storing it back on the motor unit.
symbol.