Accessories (Sold Separately); Troubleshooting Guide - Oreck XL PROFESSIONAL GRADE DS1700HY Mode D'emploi

Accessories (Sold Separately)

ITEM
1. Dust Bag, 25 Pack, Saniseal
ACDS Hypo-Allergenic
2. Belts, 3 Pack
3. 50'ft Extension Cord
USA & CANADA: 1-800-989-4244
Warranty
ORECK MANUFACTURING COMPANY: (Oreck Manufacturing
Company gives you the following limited warranty for this product only if
it was originally purchased for residential use, not resale from Oreck or an
Oreck Authorized Retail Dealer.)
Oreck will repair or replace, free of charge, to the original purchaser, any
part that is found to be defective in material or workmanship within one
(1) year. This limited warranty applies to commercial use.
Drive belts, revolving brushes, disposable bags, and other parts subject
to normal wear are not covered by this limited warranty.
This limited warranty does not apply to any part subjected to accident,
abuse, alteration, misuse, damage caused by fire or act of God, or the
use of voltages other than indicated on the serial number plate of this
product or service of this product by other than Oreck or an Oreck Factory
Authorized Service Center.
Oreck does not authorize any person or representative to assume or
grant any other warranty obligation with the sale of this product.
Oreck's limited warranty is valid only if you retain proof of purchase from
Oreck or an Oreck Authorized Retail Dealer for this product. If you
purchase this product from any other source, your purchase is "AS IS,"
which means Oreck grants you no warranty, and that you, not Oreck,
assume the entire risk of the quality and performance of this product,
including the entire cost of any necessary servicing or repairs of any
defects.
Oreck's liability for damages to you for any costs whatsoever arising out
of this statement of limited warranty shall be limited to the amount paid for
this product at the time of original purchase. Oreck shall not be liable for
any direct, indirect, consequential or incidental damages arising out of the
use or inability to use this product.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not
apply to you.
ALL EXPRESSED AND IMPLIED WARRANTIES FOR THIS PRODUCT,
INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN
DURATION TO THE WARRANTY PERIOD, AND NO WARRANTIES,
WHETHER EXPRESS OR IMPLIED, WILL APPLY AFTER THIS
PERIOD.
Some states do not allow limitations on the duration of implied warranties,
so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.
E N
PART #
®
DSPK25DW
0300604
COMMCORD50
G L I S H

Troubleshooting Guide

WARNING: Unplug cord from electrical
outlet before servicing.
SAVE SERVICE CALLS...CHECK THESE FIRST:
• Is the disposable filter dust bag full?
• Are pores of filter dust bag clogged with powder or fine dust?
• Is anything clogging the revolving brush, lower tube, intake opening,
fan housing or connector assembly opening?
• Is the belt in place and turning the brush?
• Are the brush ends in the proper location?
• Does the brush turn freely? Are hair, string or rug fibers wound around
the brush?
P
ROBLEM
C
LEANER
WILL NOT RUN
C
LEANER
DOES NOT PICK UP
ALL OTHER SERVICING SHOULD BE DONE BY AN
ORECK AUTHORIZED SERVICE CENTER.
CALL COMMERCIAL CUSTOMER SERVICE
USA & Canada: 1-800-989-4244
Whenever calling, please be sure to have your model and serial
number from data plate.
3
P S A
OSSIBLE OURCE REAS TO
Not plugged in Be sure cleaner is
properly. firmly plugged into
wall outlet.
No electricity in wall Check electrical
outlet. source–fuse or
circuit breaker.
Motor protection Check for blockage
system has inside fan housing.
engaged.
Filter bag is full. Replace filter bag. See
"To Replace Paper
Filter Dust Bag."
Nozzle or intake Clear obstruction.
clogged.
Belt is broken or Replace belt.
stretched.
Brush is worn. Rotate brush end
cards to the "OLD
(ll)" setting or
replace brush roll.
Bag tube clogged. Clear obstruction.
Bag pores are Change bag.
clogged with fine
dust.
Impeller fan is Return to Service
broken. Center for repair.
Revolving brush is Check bearing seal.
not even at both Make sure marks
ends. "OLD (ll)" or "NEW
(l)" match at each end.
C
HECK