Safeguarding The Environment; Declaration Of Conformity; Before Use; Existing Pots And Pans - Hotpoint Ariston HKID641B C Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22

SAFEGUARDING THE ENVIRONMENT

Disposal of packing
The packing material is 100% recyclable and marked with the recycling symbol (
disposed of in compliance with local regulations.
Disposal
This appliance is marked in conformity with European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE).
By ensuring that this appliance is correctly disposed of, the user can help prevent potentially negative consequences for the environment and the health of people.
The symbol
on the appliance or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to an
appropriate collection point for recycling WEEE.
Energy saving tips
For optimum results, it is advisable to:
Use pots and pans with bottom width equal to that of the cooking zone.
Only use flat-bottomed pots and pans.
When possible, keep pot lids on during cooking.
Use a pressure cooker to to save even more energy and time.
Place the pot in the middle of the cooking zone marked on the hob.

DECLARATION OF CONFORMITY

-
This appliance has been designed, manufactured and marketed in conformity with the safety requirements of "Low Voltage" Directive 2006/95/EC (replacing 73/
23/EEC as amended) and protection requirements of "EMC" Directive 2004/108/EC.
-
This appliance meets the eco design requirements of european regulation N. 66/2014, in conformity to the european standard EN 60350-2.

BEFORE USE

IMPORTANT: The cooking zones will not switch on if pots are not the right size. Only use pots bearing the symbol "INDUCTION SYSTEM" (Figure
opposite). Place the pot on the required cooking zone before switching the hob on.
Using suitable pots, the cooking zones cannot be used at temperatures below 10°C.

EXISTING POTS AND PANS

OK
Use a magnet to check if the bottom of the pot is suitable for the induction hob: bottom of the pots and pans are unsuitable if not magnetically detectable.
-
Make sure pots have a smooth bottom, otherwise they could scratch the hob. Check dishes.
-
Never place hot pots or pans on the surface of the hob's control panel. This could result in damage.

RECOMMENDED POT BOTTOM WIDTHS

Place the pot on the required cooking zone before switching the hob on.
For good cooking results, the diameter of the base of the pot should match the size of the hotplate.
Diameter (cm)
Max (cm)
14.5
18
21
24
26
Pan size
To determine the size of the pot please measure the base of the pot (see picture) and refer to recommended pots bottom width table,
reported below, for perfect usage and correct pan detection. Each cooking zone has a minimum limit of detecting pans, which varies
depending on the material of the pan being used. You should therefore use the cooking zone that is most suitable for the diameter of
your pan.
NO
Min (cm)
14.5
10
18
12
21
15
24
15
26
17
). The various parts of the packing must not be dispersed in the environment, but
Diameter (cm)
28
30
FLEXI/CONNEXION
EN6
Max (cm)
Min (cm)
28
17
30
17
39 - 18
12

Publicité

Table des Matières
loading

Table des Matières