Polaris 2879220 Manuel D'installation page 28

"GLACIER PRO" HYDRAULIC PLOW LIFT CONTROL KIT
KIT PN 2879220
4. Position the strap link (#8) on the frame and insert
the strap link pin (#11) in the frame.
Lock it in place with the "R" pin (#16).
Figure 23
5. Route the power wires between the motor and the lift
cylinder as shown in figure 24.
Figure 24
6. The clip that was installed in step 5 (in Wiring Kit
Assembly Section) should now be pushed into the ¼"
hole on the right hand side of the mid frame as shown
in figure 25.
7515264
A-7515264
Figure 25
7. Reconnect the battery at this time.
8. Attach the plow system to the unit and connect the
lift cylinder wire to the plow control wire.
9. Check operation to make sure the lift system works
properly. Check all wire routings to make certain
wires are free to move during plow installation and
removal.
10. When plow system is removed from the unit the plow
control wires should be connected to the cap installed
on the grille in step 3 (in Wiring Kit Assembly Section)
to prevent moisture and debris from entering the plug
as shown in figure 26.
Figure 26
- 12-
Printed in China