Polaris 2879220 Manuel D'installation page 23

"GLACIER PRO" HYDRAULIC PLOW LIFT CONTROL KIT
KIT PN 2879220
c. From the front of the unit the harness plug
should be routed through the right hand
bumper opening and pass through the right
hand side of the P/N 5257055 grille insert.
The locating clip on the P/N 2412369 control
harness (#3) should be secured into the
locating tab on the grille as shown in figure 4.
Figure 4
d. Install the new grille insert at this time using
the hardware that was removed in step 3. If a
winch fairlead was removed it should also be
reinstalled at this time.
e. Attach the red power and black ground leads
of the P/N 2412369 control harness (#3) to the
corresponding leads on the accessory block
at this time. The accessory block is located
under the hood on the RH side as shown in
figure 5.
Figure 5
7515264
A-7515264
Accessory Power Block
f. The white plug on the plow harness should be
attached to the plow control harness that was
previously installed in the unit.
g. Use one of the panduit straps (#4) provided in
this kit to secure the plow control harness to
the main frame near the front bend as shown
in figure 6.
Figure 6
h. Check to make sure all connections are
secure and use the remaining P/N 7080492
panduit straps (#4) to secure the harness as
necessary. Take care to position the relays
and circuit breaker in an area where they will
not be damaged during operation.
6. Install the P/N 7670102 routing clip (#6) to the
harness of the P/N 2879221 lift cylinder (#1) 10"
from the end of the plug as shown in figure 7.
P/N 7670102 Clip
Figure 7
- 7-
Panduit Strap
Printed in China