Polaris 2879220 Manuel D'installation page 26

"GLACIER PRO" HYDRAULIC PLOW LIFT CONTROL KIT
KIT PN 2879220
ASSEMBLY INSTRUCTIONS FOR RANGER FULL SIZE
500, 700, AND 800 MODELS
(FOR RANGER 900 MODELS, SEE PAGE 6)
WIRING KIT ASSEMBLY INSTRUCTIONS:
1. Open center hood panel and disconnect the battery
prior to starting this installation.
2. Use a T-27 Torx bit to remove the stock grille insert
from the bumper at this time retaining hardware for
reuse.
3. Remove the protective cap from the P/N 2412369
control harness (#3) and secure it to the right hand side
of the P/N 5257056 grille with the P/N 7621472 rivet
(#5) as shown in figure 1. The P/N 5257056 grille can
be found in the P/N 2879105 mount kit. If the unit has
a winch the insert will need to be removed from the
grille by clipping the tabs as shown in figure 15.
Figure 15
4. Follow the below instructions for proper wire routing:
a. Route the plug of the P/N 2412369 control
harness (#3) through the gap between the
hood liner and the front bumper fascia on the
right hand side as indicated in figure 16.
Figure 16
7515264
A-7515264
b. From under the right hand fender route the
cable to the inside of the bumper to where the
grille insert was removed as shown in figure 17.
Figure 17
c. From the front of the unit the harness plug
should be routed through the right hand side
of the bumper opening and pass through the
right hand side of the P/N 5257056 grille
insert. The locating clip on the P/N 2412369
control harness (#3) should be secured into the
locating tab on the grille as shown in figure 18.
Figure 18
- 10-
Printed in China