Polaris 2879220 Manuel D'installation page 22

"GLACIER PRO" HYDRAULIC PLOW LIFT CONTROL KIT
KIT PN 2879220
ASSEMBLY INSTRUCTIONS FOR RANGER 900 MODELS
(FOR RANGER FULL SIZE 500, 700, AND 800 MODELS, SEE PAGE 10)
WIRING KIT ASSEMBLY INSTRUCTIONS:
1. Open the passenger side seat, remove the storage
compartment and disconnect the battery prior to
starting this installation.
2. Remove the center hood section from the machine
and determine if the unit has 6 gage power and
ground cables going to the accessory block. If the
unit does not already have power and ground cables
going to the accessory block the P/N 4014060 wire
kit should be installed at this time. Do not connect
the wires to the battery until installation of the lift kit
is complete.
3. Use a T-40 Torx bit to remove the plastic grille insert
from the bumper at this time retaining hardware for
reuse. Take note that the fairlead will also need to be
removed if a winch was previously installed on the
unit.
4. Remove the protective cap from the P/N 2412369
control harness (#3) and secure it to the right hand
side of the P/N 5257055 grille with the P/N 7621472
rivet (#5) as shown in figure 1. The P/N 5257055
grille can be found in the P/N 2879106 mount kit.
P/N 7621472 Rivet
Protective Cap
Figure 1
7515264
A-7515264
P/N 5257055 Grille
- 6-
5. Follow the below instructions for proper wire routing:
a. Route the plug of the P/N 2412369 control
harness (#3) through the right hand routing
hole found under the center hood of the unit
as shown in figure 2.
Routing Hole
Figure 2
b. From under the right hand fender route the
cable along the top of the main frame tube
passing the plug through the routing hole
provided on the lower left hand side of the
radiator shroud as shown in figure 3.
Routing Hole
Figure 3
Accessory Power Block
Printed in China