Settings Menu - Becker Centronic SunWindControl SWC52 Notice De Montage Et D'utilisation

Assembly and Operating Instructions

Settings menu

SETTING menu
The following settings can be made via the SETTING menu:
• SUN t (if a sensor is connected)
• DELAY t (only possible if expert mode is activated and a sensor is connect-
ed)
• SUN s (if a sensor is connected)
• DELAY s (only possible if expert mode is activated and a sensor is connect-
ed)
• INTERMEDIATE POSITION
• CANOPY TENSION
• WINTER OFF/ON
• WIND CONTROL
• TIME END LIMIT/INTERMEDIATE POSITION/ CANOPY TENSION (only for
pre-programmed switching or blocking time)
• LIGHT END LIMIT/INTERMEDIATE POSITION/CANOPY TENSION (if a sensor
is connected)
• TEST MODE ON/OFF(if a sensor is connected)
• Language selection (ENGLISH GB)
• SUMMER/WINTER (automatic clock adjustment for daylight saving)
To make settings, press the OK button repeatedly until you reach the menu level
required.
SUN t/ SUN s
The threshold value for SUN t is pre-set to 04 and for SUN s to 03.
The value – indicates that the sunshade function has been deactivated. The
brightness value can be set to values ranging between 01 (very overcast) and
15 (direct sunlight).
The existing sunlight setting and the new setting to be made are shown on the
display. The field for the new sunlight setting flashes.
DELAY ts (only when EXPERT MODE is ON)
The delay time t is pre-set to 3 min and the delay time s is pre-set to 15 min.
The delay time t indicates the period between the moment the threshold set-
ting SUN t is exceeded and the control command is executed.
This setting can be made manually.
The delay time s indicates the period between the moment the sunlight reading
falls below the pre-set threshold value SUN s and the 'retract ' control com-
mand is executed.
This setting can be made manually.
36