CDVI STAR1M Manuel D'installation page 11

INSTALLATION MANUAL
STAR1M - Standalone Access control system / 13,56 MHz Mifare
4] MOUNTING
1
Trace the markings to fix the product using
the back casing. Drill the fixing support using
the markings (recommended diameters: Ø5
mm and Ø15 mm). Using the wiring diagram,
plan for the cable exits hidden under the sur-
face or outside (trunking).
Fit the anchors in the holes, pass the cable and connect it (see wiring diagram on page 14),
3
then fix the reader using the TORX
varistor at the locking system level (see "Reminders and recommendations" on page 12).
Fig. a
2
Fit the seal on the back plate starting
from the bottom. (fig. a). The seal must
overlap the back part of the reader by about
2 mm (fig. b).
Ø 15
Ø 5
screw using the TORX
®
tool (fig. c). Remember to fit the
®
cdvigroup.com
EN
reader
®
Fig. b
Fig. c
11