Product Presentation; Reminders And Recommendations; Mounting Kit - CDVI STAR1M Manuel D'installation

INSTALLATION MANUAL
STAR1M - Standalone Access control system / 13,56 MHz Mifare

1] PRODUCT PRESENTATION

- 2-in-1 product:
- standalone Access control system operation
- Mifare reader (13.56 MHz) operation
®
- Resin-coated electronics
- Audible and visual feedback
- 3m of cable (10 leads - AWG28)
- Available version black
- Up to 300 cards (standalone)
Dimensions (L x W x D): 130 x 41 x 28 mm
Technology: 13.56 MHz
Protocol: Mifare classic
®
Power supply: 12 V dc
Consumption: 200 mA
Wiegand 26/30/44 bits (reader Mifare
DEEE
IP54
Certification CE

2] REMINDERS AND RECOMMENDATIONS

Installation recommendations
To protect the device from back-emf,
do not forget to install the varistor
across the lock terminals, in parallel.
Recommended cable
10-lead cable (AWG28)
Recommended power supplies
ADC335 and BS60 (in case the reader
is powered neither by the controller nor
by the reader controller [INTBUSW]).
Environment
When in a humid area or close to the
sea, we recommend applying varnish to
the terminals to avoid oxidation.

3] MOUNTING KIT

Leaktight
seal
STAR1M 1
10
cdvigroup.com
-25°C à +70°C
FCC Certification CFR 47
part 15 compliance
This product is shipped with a
varistor.
The varistor must be connected directly
to the locking system terminals (electric
strikes, electromagnet, or lock) operated
by the device. If the device functions
with several locking systems, each one
must be fitted with a varistor. The varis-
tor limits overload produced by the strike
coil, known as self-effect or back-emf. If
you are using a "Shear Lock", electro-
magnet or other type of electric lock, we
recommend the use of dedicated power
supply for the lock.
TF 3x30 S5
Screws Plastic anchor Screwdriver tip
2 2
)
®
TORX TORX 3x8
® ®
Screws
1 1
EN
reader
®
STAR1M
For optimum
lighting, be
careful to not
fold the cable
inside the
product.
Varistor METAL card
1 1
30