Warranty Limitations - MITACA i5 Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Problem
Selecting the
distribution button
(D-E) you cannot
get a beverage.
The lever (1) will not
slide properly.
Problem
Coffee/tea is no longer
dispensed
It is not possible to dispense
coffee, tea, or boiling water
Coffee/tea is cold
The pump is too noisy
A few drops come out of the
dispenser, especially when the
machine is warming up
Coffee tastes sour
When buttons (B) and (C) are
pressed the milk is watery

WARRANTY LIMITATIONS

Warranty does not cover repairs caused by:
-Malfunctions caused by water scale and by failure to periodically de-scale the unit
-Malfunctions caused by operating the machine at voltages other than that specified on the nameplate
-Malfunctions caused by improper use or non-adherence to the instructions for use
-Malfunctions caused by alterations made inside the machine
Solution
1) Fill the tank with water
2) Check if the water tank is well located.
3) Lift the lever to permit air outlet take the capsule
off and wait for a while to let the pump be cool ,
close the lever again and select the distribution
(D-E)
button
.
4) Empty the capsule receptacle and reset the
coffee function: turn the machine off and on again
switching the main switch (2) off and on.
If you cannot solve the problem, you are
kindly requested to contact your service center.
Press the start button (D-E), then open and close the lever (1) several times
while water is being dispensed.
Causes
- the tank is empty
- the pump is defective
- the water tank is not fully seated
- pump not working
- the heating system is defective - contact the dealer
- the tank is empty
- the water tank is not seated
properly
- this is not a fault
-the machine was not rinsed
properly af ter descaling
- The milk container (15) is empty - Fill the container (15) with
29
Corrective action
- fill the tank
- contact the dealer
- seat the tank properly
- contact the dealer
- fill the tank
- seat the tank properly
- it is normal for a few drops to
come out, this is not a defect
- re-rinse the machine
powdered milk
1

Publicité

Table des Matières
loading

Table des Matières