Matfer 240302 Notice D'utilisation page 25

ENGLISH
User manual MAT1800, MAT2800, MAT 3500 and MATW3500 products
Small breakdowns and solutions:
YOU NOTICE THAT...
On turning on, a light display
appears
On turning on, your
installation short circuits.
The fan continues for a few
minutes after turning the
appliance off.
The appliance doesn't work.
The light displays on the
panel remain off.
The "F" display then "-"
appears on the power
display.
The "F" display then "7"
appears on the power
display.
The appliance doesn't work;
another code is displayed
on the power display.
After starting the heating
zone, the light indicator
chosen continues to flash.
The saucepans make a
noise during cooking
The appliance gives off a
smell on using the first few
times.
In case of even a slight breakage, crack or fissure to the vitroceramic bowl, unplug.
THE POSSIBLE CAUSES
Normal working
The connection of your
appliance is faulty.
Cooling down of the
electrics.
The appliance has no
power supply. The power
supply or connection is
faulty.
There is a pad
permanently activated on
the control panel.
The electronic circuits are
overheating.
The electronic circuits are
not working properly.
The container you are
using is not adapted to
cooking by induction or is
of a diameter less than 12
cm.
This is a vibration
generated by the
circulation of the current in
the container.
New appliance
WHAT TO DO?
NOTHING: it's normal
Check your connection
or the conformity of the
connection.
It's normal.
Inspect the fuses and
the circuit breaker of
your electrical
installation.
If the fault doesn't
disappear, call the After-
sales Service.
Inspect the fan of the
appliance and see if it is
working.
Call the After-sales
Service.
See Pots and Pans
section.
This phenomenon is
normal with certain
types of saucepan.
There is no danger for
the appliance.
Operate the hob for ½
hour with a saucepan
full of water.