Permanent Installation Instructions; Before You Start; Drain System; Connect Drain Hose - Crosley CAWC529PQ0 Guide D'utilisation Et D'entretien

PERMANENT INSTALLATION INSTRUCTIONS

Before You Start

WARNING
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
To prevent floor damage, set the washer onto cardboard
before moving across floor.
Move the washer to within approximately 3 ft (90 cm) of the
final location.

Drain System

The washer can be installed using the standpipe drain system
(floor or wall), the laundry tub drain system, or the floor drain
system. Select the drain hose installation method you need. See
"Tools and Parts."
Standpipe drain system - wall or floor (views A & B)
The standpipe drain requires a minimum diameter standpipe of
2" (5 cm). The minimum carry-away capacity (for permanent
installations) can be no less than 13 gal. (49.2 L) per minute. A 2"
(5 cm) diameter to 1" (2.5 cm) diameter standpipe adapter kit is
available. See "Tools and Parts."
The top of the standpipe must be at least 39" (99 cm) high and no
higher than 72" (183 cm) from the bottom of the washer.
A
Laundry tub drain system (view C)
The laundry tub requires a minimum carry-away capacity of
13 gal. (49.2 L) per minute (for permanent installations).
The top of the laundry tub must be at least 39" (99 cm) above the
floor and no higher than 72" (183 cm) from the bottom of the
washer.
39"
(99 cm)
B
Floor drain system (view D)
The floor drain system requires a siphon break that may be
purchased separately. See "Tools and Parts."
The siphon break must be a minimum of 28" (71 cm) from the
bottom of the washer. Additional hoses might be needed.
The minimum carry-away capacity (for permanent installations)
can be no less than 13 gal. (49.2 L) per minute.
(99 cm)
C

Connect Drain Hose

Proper connection of the drain hose will protect your floors from
damage due to water leakage. To prevent the drain hose from
coming off or leaking, it must be installed according to the
following instructions.
IMPORTANT: To ensure proper installation, this procedure must
be followed exactly.
1. Check the drain hose to see that it is the proper length.
2. Wet the inside of the straight end of the drain hose with tap
water.
IMPORTANT: Do not use any lubricant other than water.
3. Squeeze ears of double-wire clamp with pliers to open. Place
clamp over the straight end of the drain hose ¹⁄₄" (6 mm) from
the end. Twist hose back and forth while pushing down onto
drain connector at the bottom of the washer. Continue until
hose contacts the cabinet.
4. Place clamp over area marked "CLAMP." Release clamp.
¼"
(6 mm)
A. Drain hose
B. Clamp
C. Cabinet
39"
¼"
(6 mm)
A
B
¼"
(6 mm)
C
D
7