Indel Webasto Marine Compact Classic Instructions Pour L'installation Et L'utilisation page 69

User Manual
Installation of evaporators to be bent
1. Carefully plan the position of the evaporator. Begin by identifying the position
on the side of the compartment where you can make a hole in which to pass
the quick couplings.
2. The evaporator must be installed so that it covers as wide an area as possible
of the vertical walls. For freezer version installation, it is advisable to reach 2 or
more sides where possible. The evaporator must be installed as high as possible
inside the compartment to be cooled to optimise yield and temperature
distribution inside the compartment.
3. It is very important that the short part of the hose attached to the evaporator
via a jumper remain directed towards the wall.
Be sure to leave enough space for this hose because it should not be removed
in any case from its mounting to alter the length.
4. The measurement for bending the evaporator must be made directly inside the
compartment where it will be installed. As a first step, start from the side of
the evaporator where the gas input/output hoses are present and measure the
length in order to make the first bend: with this measurement, keeping mind
the space for inserting the hose in the provided hole (consider a space from
40mm to 80mm, proportional to the height of the evaporator, from the edge of
the wall to the edge of the evaporator, to facilitate insertion of the latter in the
compartment), the range of evaporator bending and any spacers to fasten the
evaporator to the wall. Below is an example of the measurement calculation
to perform bends on the evaporator (Figure 6): the evaporator is represented
in black on the inside, considering a vertical section of the positioning
compartment.
IMPORTANT: Always check that the detected bending point is included in the
bending zones indicated in the drawings contained in the manual.
The bending zones are indicated based on the models at the end of this manual
under "Bending Zones."
69