Fluval Aquasky Mode D'emploi page 3

INSTALLATION AND USAGE:
Please verify that all components of the light fixture are undamaged before putting it
into operation. Before any kind of maintenance, always disconnect electrical supply
of the light fixture.
• Make sure the light fixture is mounted correctly and securely positioned on the
aquarium before operating the appliance.
• On a plain glass aquarium always ensure that the brackets are on the outside of
the aquarium frame. If needed, the extendable mounting brackets can be adjusted
accordingly to ensure proper fit on aquarium.
• Connect the plug from the transformer to the plug on the fixture.
• Connect the transformer to electrical supply.
CONTROLLABLE
FULLY
For full instruction manual and video on set up of Bluetooth® application, visit:
fluvalaquatics.com/aquaskybluetooth
MOUNTING BRACKET INSTRUCTIONS:
This is a mounting system only and does not provide power to the LED strip.
REMOVING THE EXISTING LIGHT TUBE
• Disconnect the T8/T5 lighting system from the power supply and do not reconnect.
• Please ensure that the LED strips are not connected to the power supply when
mounting into the T8/T5 lighting system using the mounting brackets.
• Unscrew both end caps and move them into the center of the tube.
• Remove the tube by sliding it gently out of the fitting.
INSTALLING THE MOUNTING BRACKETS
• Clip the mounting brackets over the ends of
the extending arms of the LED strip, as per
the photo (A). You may need to pull out the
extending arms slightly to do this.
• For T5 lighting systems: fit the end caps over
the end of the mounting brackets, to face
inwards.
• For T8 lighting systems: click to fit the T8
ring adapter onto the end of each mounting
bracket, then follow the instructions above for
T5 lighting systems.
• Fully tighten the end caps back onto the
threads, being careful not to cross thread or
over tighten. You may need to extend or retract
the extending arms to make the LED strip fit
perfectly (B).
• WARNING: Before connecting the power supply, ensure that the LED strip is
securely fastened to lighting system of the aquarium so that it is stable and cannot
fall into the water. The LEDs are tested to IPX7, which means they can withstand
temporary submersin. NOTE: THIS IS NOT A SUBMERSIBLE LIGHT.
• Clip the mounting brackets over the ends of the extending arms of the LED strip, as
Connect the power supply to the LED strip and switch on.
INSTALLING THE CEILING BRACKET
• Clip the ceiling brackets over the back
(side with fins) of the LED strip.
• Use suitable fixings for the intended mounting
surface. If you wish to bond the brackets to
glass or plastic use aquarium silicone.
• WARNING: Do not screw the bracket onto
any housing containing electrical wiring or
connections, such as lighting ballasts, due to
severe risk of electric shock.
SMART PHONE
FROM YOUR
SCAN HERE to learn more
and download the free Fluval Smart app
or search 'Fluvalsmart' in app store.
TABLET
OR
A
B