SEVERIN SC 7172 Mode D'emploi page 17

Appliance maintenance and ordering spare parts
Emptying and cleaning the dust container
Troubleshooting by yourself
The dust container can only hold a limited quantity of dirt.
It is therefore best to empty the dust container after every cleaning procedure.
1. Make sure that the appliance is switched off and is not on charge.
2. Remove the hand-held vacuum from the appliance, see chapter „Use as a hand-held vacuum".
3. Unlatch the dust container and remove the filters.
4. Empty the dust container and clean the filters if necessary.
For further information, see also illustrated quick start guide
So that as few problems as possible arise, it is important to empty the dust container regularly and
to take this opportunity to check the filters and clean them if they are dirty.
Problem
Appliance can not
be switched on.
The appliance
can not be
charged (LED
does not blink).
The appliance
has lost suction
power.
Operating dura-
tion is becoming
ever shorter.
If you can not solve the problem using the table above, call our Service hotline (see contact infor-
mation in the appendix to this instruction manual). The motor protection filter, article number
8608048 can be conveniently ordered via the internet under http://www.severin.com/go/to/8364
in the menu "Service/Spare Parts Shop" or through our customer service department.
SC 7172.book Seite 17 Montag, 5. Oktober 2015 2:12 14
4 Appliance maintenance and ordering spare parts
Possible cause/Remedy
Rechargeable battery is completely discharged. Switch off the appliance and
charge rechargeable battery, chapter „Charging the battery and operating
the appliance".
Mains adapter is not plugged in correctly. Check whether the mains adapter
or adapter plug is seated properly in the outlet (chapter „Charging the bat-
tery and operating the appliance").
The appliance does not sit correctly on the charger. Place the appliance on
the charger correctly.
The dust container must be emptied or the filters must be cleaned, chapter
„Emptying and cleaning the dust container".
It is possible that dirt is preventing the brush roller from rotating freely. Free
the brush roller of dirt (illustrated quick start guide). If necessary, carefully
use a pair of scissors or tweezers to do this.
17