Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Night mode allows you to maintain a constant temperature
in a room without major fluctuations in temperature or
humidity. The fan speed will remain low while the temperature
and humidity level of the room will only change gradually to
guarantee the highest possible level of comfort.
In AIR-CONDITIONER mode, the selected temperature will
increase by 1°C per hour over a period of 2 hours. This new
temperature level will then be maintained for the following 6
hours. The appliance will then switch itself off.
In HEATER mode, the selected temperature will be reduced
by 1°C per hour for a period of 3 hours. This new temperature
will then be maintained for the following 5 hours. The
appliance will subsequently switch off.
NIGHT mode can also be cancelled at any time during use by
pressing the
or
or
In FAN mode, the NIGHT function cannot be set.
PROGRAMMING
•
Setting the timer
This timer can be used to set the appliance to switch on
or off at a chosen time. This will allow you save on power
consumption by optimising the periods when it is in use.
Setting the appliance to switch on
•
Switch the appliance on.
•
Choose the mode you want to use, such as AIR-
CONDITIONER mode set to 24°C at maximum fan speed,
for example.
•
Then switch the appliance off.
•
Press the
button. The screen will display 1-24 hours
and the
,
and
•
Press
several times until amount of time you want is
displayed. Wait for around 5 seconds, then the timer will
be activated and only the
the screen (Fig. 4).
•
To cancel the programme that has been set, press the
button
again or press the
will disappear from the screen.
28
buttons.
will flash together (Fig. 3).
symbol will be displayed on
button. The
Setting the appliance to switch off
•
When the appliance is operating, press the
The screen will display 1-24 hours and the
symbols will flash together (Fig. 5)
•
Press the button several times until the time you want is
displayed. Wait for around 5 seconds, then the timer will
be activated and only the
the screen (Fig. 6).
•
To cancel the programme, press the
press the
the screen.
CHANGE UNIT OF TEMPERATURE
When the appliance is in standby mode, press the
for 20 seconds. You can then change the unit of temperature.
Before modification, in Cold mode, the screen will appear as
in Fig. 1.
After modification, in Cold mode, the screen will appear as
in Fig. 2.
symbol
FR
symbol will be displayed on
button. The
symbol will disappear from
www.ewt-france.com
EN
NL
button.
,
and
button again or
button
Publicité
Table des Matières
