Troubleshooting Table - Pekatherm F70 Manuel D'utilisation

PROblEm
1. W hen the product is
plugged in, the digital display
indicator do not light.
2. After pushing the ON/OFF
button on the control unit,
the control unit fails to set
at the default temperature
level, and the product does
not warm up.
3. T he product does not
warm up.
4. A fter a period of proper
functioning, the digital
display indicator go off, only
digital dot remains lit on the
digital display indicator, and
the product stops warming.
5. T he control unit appears
to malfunction: the
digital diplay indicator flash
continuously or shows
strange symbols.
INSTRUCTIONS

TROUblESHOOTING TablE

Check whether your mains socket has power; check whether
the product is plugged in correctly. Unplug the product and
wait a few seconds, then plug it in again. Push the ON/OFF
button on the control unit.
The control unit may have found an error at the start and
blocks the product operation for safety. Check if the digital
display indicator has any special flashing.
Unplug the product from the mains, wait a few seconds and
plug it in again. If the problem persists, take the product to an
authorized service centre.
Make sure the product is powered, by checking whether the
digital display indicator on the control unit is lit. Make sure the
product is operating, by checking whether the digital display
indicator on the control unit is set at any temperature level.
Remember that the safety AUTO-OFF function may have
switched the product off if the safety time period is over. If
that's the case, push the ON/OFF button to switch the product
on. In case of any doubt, reset the product by unplugging it
from the mains and plugging it in after a few seconds.
In order to ensure safety in use, all our products are provided
with a safety AUTO-OFF option which switches the product off
after a certain number of hours of continuous operation. The
period is 2 hours for footwarmers. See SAFETY ELEMENTS
paragraph for details.
If you want to turn on the product, just push the ON/OFF
button on the controller.
The control unit may have found a problem and blocks the
product operation for safety. Unplug the product from the
mains, wait a few seconds and plug it in again. If the problem
persists, take the product to an authorized service centre.
26
SOlUTION