Tone Generator - Softing CableMaster CM600 Guide De Démarrage Rapide

TONE GENERATOR

• Power on the CableMaster 600/650.
• Use the left or right arrow buttons to
select the tone generator
icon and press the enter button.
• The CableMaster 600/650 will automatically
activate the tone generator upon entering the
tone generator menu.
• Connect your cable to either the RJ45 jack
or coax connector located on the top of the
CableMaster 600/650.
• To switch between network and coax cables, press the coax cable/RJ45 soft key
/ .
• Press the up or down arrow buttons to select tone cadences 1 thru 4.
• Press the left or right arrow buttons to select which pin or pair to place the tone.
• Use a tone probe (P/N TP200 TrakAll) alongside the cable or at the end of the cable
to hear an audible tone.
SETUP
• Press the setup softkey
• Use the up and down buttons to select a setting.
• Use the left and right arrow buttons to change the selected setting.
• Press the save soft key
• Press the defaults soft key
• Press the Files soft key
CM 600/650 SOFTWARE APPLICATION
To install the CableMaster 600/650 software please download the newest software
version at http://itnetworks.softing.com
to enter the setup menu.
to save changes.
to reset the settings to factory settings.
to view stored test results.
5