Siting; Loading The Filter Media - BWT P-FI 400 Notice D'installation Et Conseils D'utilisation

2.

SITING

The filtration group must be installed on a flat, level surface and at a distance of at least 3,5 m from the water
(French standard C15-100). The electrical supply must be protected by 30mA differential circuit breaker.
The filter group should be installed close to a drain or waste line to facilitate evacuation of backwash water.
3.

LOADING THE FILTER MEDIA

1
Unscrew and remove the ring.
3
Glueing the unions to the lid: The transparent union
to the waste outlet, the black or grey unions to the
pump inlet and outlet.
Caution: avoid using excess glue, this could
dammage the valve
14/32
2021/01 - Indice de révision : G - Code : 26650
2
Remove the lid/valve assembly (positioned upside-
down during transport).
4
Screw in the drain plug.
FILTRATION