stayer BHL112K Instructions D'emploi page 15

Declaration of Conformity
The undersigned: STAYER IBERICA, S.A.
With address at:
Calle Sierra de Cazorla, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.: +34 91 691 86 30 / Fax: +34 91 691 91 72
CERTIFIES
That the machine:
Cordless drill/screwdriver
Type:
Models: BHL112K / PBL120K PBL211K /
PBL141K / PBL142K / PBL143K /
PBL181PK / PBL182PK / PBL183PK
We declare under our sole responsibility that this
product is in conformity with the following standards or
standardized documents: UNE EN 60745, according to
EU Regulations 2006/42/CE, 2004/108/CE.
Ramiro de la Fuente
Director General
Assembly
Battery Charging
f Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
Do not continue to press the
WARNING
On/Off switch after the ma-
chine has been automatically switched off. The
battery can be damaged.
To remove the battery 5, press the battery un-
locking button 9 and pull the battery out of the
power tool toward the rear. Do not exert any
force.
ENGLISH
13
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0º C and 45º C. A
long battery service life is achieved in this man-
ner.
Observe the notes for disposal.
Changing the Tool
f Before any work on the machine (e. g .,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the centre posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
Open the keyless chuck 2 by turning in rotation
direction , until the tool can be inserted. Insert
1
the tool.
Firmly tighten the collar of the keyless chuck 2
by hand in rotation direction
cally locks the drill chuck.
The locking is released again to remove the tool
when the collar is turned in the opposite direc-
tion.
Dust/Chip Extraction
f Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcino genic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Pro v ide for good ventilation of the work-
ing place.
– It i s recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
13
. This automati-
2