Preparation - Velleman CS130 Notice D'emploi

Discrimination
Since any given metal will respond with its own characteristic phase shift, it will be possible to
•
distinct between them. The process of distinguishing between different metals is called
discrimination.
Ground balance
As mentioned earlier, soils that contain iron will produce a response signal which can be a lot
•
stronger than the signal produced by a metallic object concealed in it. This is also the case for
places where ground water contains a lot of dissolved salt.
However, the phase shift caused by the ground, the ground effect, remains fairly constant over a
•
limited area when the search head is kept at a steady height.
Accurate ground balance makes it possible to precisely pin-point the location and depth of an
•
object.

7. Preparation

The CS130 comes fully mounted. Carefully unpack it.
•
Loosen the locking nut [F] and slide the lower shaft [G] out of the upper shaft [E] until the
•
desired length is reached.
Note: the coils' wiring runs inside the stem. Do not force to avoid damage.
To determine the ideal shaft length, stand upright holding the metal detector by the handle [B]
•
and your arm on the arm rest [A]. When holding your arm relaxed next to your body, the search
coil [I] should be about ½" to 2" (max.) (1.5~5cm) above the ground.
Turn the locking nut [F] counter clockwise (top view) to secure the lower shaft.
•
Loosen the search coil knob [H], adjust the search coil [I] so it is parallel to the ground and
•
tighten the nut knob.
Insert the battery (see §14).
•
8. Operation
It is strongly advised to test the detector at home before going into the field. Perform tests with
•
different metals e.g. coins, golden ring, silver spoon...
Perform indoor tests by placing the detector on a wooden or plastic table, search coil [I]
o
facing the ceiling and slowly moving a metal object over the coil. Be sure not to wear
jewellery as these will influence the reading. Hold the metal object under different angles
while moving across the coil and notice the difference in detection. Note that the volume will
increase quickly as the metal object passes directly in front of the search head, with the
loudest signal occurring when the search head is centred immediately over the metal object.
As the object passes beyond the search head the signal will quickly fade.
Note: Never test the detector on a floor inside a building. Most buildings have metal of some
kind in the floor, which might interfere with the objects you're testing or mask the signal
completely.
The search coil will not detect without motion. You must move the object since you are
not sweeping with the detector at this time.
If the detector does not detect the material, check the battery power and verify that the
search coil is properly connected.
Also perform outdoor tests to learn the influence of the soil type on the detector and to
o
practise ground balancing. Place a metal object on the ground and slowly sweep the search
coil [I] over it. Be careful when using valuable metals for outdoor testing – make sure you
can always retrieve them.
Switch on the detector by turning the VOLUME button [2] clockwise. To switch it off, turn the
•
button counter clockwise until it clicks.
When desired, plug a headphone (not included) with a 3.5mm plug into the headphone jack [4].
•
Set the speaker (or headphone) sound level using the volume button [2].
•
When the low battery indication [1] lights up, replace the batteries to ensure detecting accuracy.
•
Set the DISC button [5] about halfway.
•
10/10/2014
CS130
UNLOCK
5
LOCK
© Velleman nv