Changing Operating Mode; Turning The Economy Function On/Off; Enabling/Disabling Electric Heater Operation; Enabling/Disabling Minimum Room Temperature Control - Daikin FWECSA Manuel D'installation Et D'utilisation

CHANGING OPERATING MODE

To change the operating mode (Cooling/Heating) press the
MODE key from the main screen.

TURNING THE ECONOMY FUNCTION ON/OFF

To turn the ECONOMY function on it is necessary to view the
main screen. From here:
• press the UP/DOWN keys to scroll through the screens
until you get to the "Turning the economy function On"
mask;
• press the SET key to enter edit mode;
• press the UP/DOWN keys to turn the function on/off and
press the SET key again to confirm;
• press the ON/OFF key to go back to the main screen.
If the function is on, the economy symbol will appear in the
main screen.
ENABLING/DISABLING ELECTRIC HEATER
OPERATION
To enable/disable electric heater operation (if installed and
configured) you must go to the main screen. From here:
• press the UP/DOWN keys to scroll through the screens
until you reach the 'turning the heater on' mask;
• press the SET key to enter edit mode;
• press the UP/DOWN keys to enable/disable the function
and press the SET key again to confirm;
• press ON/OFF to go back to the main screen.
If the electric heaters are enabled (and configured correctly
in the CONFIGURATION MENU) the heater symbol will appear
on the main screen; it will flash if the heaters are not running,
or it will appear steady if the heaters are running.
ENABLING/DISABLING MINIMUM ROOM
TEMPERATURE CONTROL
To enable/disable the minimum room temperature control
function it is necessary to go to the main screen. From here:
• press the UP/DOWN keys to scroll through the screens
until you reach the turning the minimum temperature
control on mask;
• press the SET key to enter edit mode;
EN
5
Controller for units
OPERATION MANUAL
It is strictly forbidden to reproduce this manual, even partially
• press the UP/DOWN keys to enable/disable the function
and press the SET key again to confirm;
• use ON/OFF to go back to the main screen.
If the function is on, the minimum temperature symbol will
appear in the main screen.
TURNING AMBIENT HUMIDITY CONTROL ON/
OFF
To turn the ambient humidity control on/off you must go the
the main screen and there must be a humidity probe. From
here:
• press the UP/DOWN keys to scroll through the screens
until you get to the "Turning the humidity control on" mask;
• press the SET key to enter edit mode;
• press the UP/DOWN keys to enable/disable the function
and press the SET key again to confirm;
• use ON/OFF to go back to the main screen.
CHANGE THE HUMIDITY SET
To change the value of the ambient humidity set you must
go back to the main screen and have turned the ambient
humidity controller on. From here:
• press the UP/DOWN keys to scroll through the screens
until you get to the "Humidity setpoint" mask;
• press the SET key to enter edit mode;
• press the UP/DOWN keys to enable/disable the function
and press the SET key again to confirm;
• press ON/OFF to go back to the main screen.

TURNING THE TIME SLOTS ON/OFF

To turn the time slots on/off quickly, it is necessary to go to
the main screen (with the unit either on or off).
Press the SET and DOWN ARROW keys at the same time.
The clock symbol on the main screen means that the time
slots are on.
FWECSA
FC66003946
Rev 00