HAEGER Eco Desumi 10 Série Mode D'emploi page 10

English
NOTE
1. Do not remove the float from the water tank. The
water full sensor will no longer be able to detect
the water level correctly without the float and
water may leak from the water tank.
2. If the drainage tank is dirty, wash it with cold or
lukewarm water. Do not use detergent, scouring
pads, chemically treated dust cloths, gasoline,
benzene, thinner, or other solvents, as these can
scratch and damage the tank and cause water
leakage
3. When replacing the drainage tank, press the tank firmly into place with both
hands. If the tank is not positioned properly, the "TANK FULL" sensor will be
activated, and the dehumidifier will not operate.
Continuous water drainage
If the appliance is to be operated for long periods but you are unable to empty
the tank regularly, you are recommended to use the continuous drain facility.
1. Plug a plastic pipe (with an inner diameter of 10mm) to draining hole.
2. Draining tube should place lower than the draining hole to let water flow
out.
Note: Water pipe cannot be too long (usually 0.6m or 1m), the height cannot
surpass the height of drainage mouth, or there will be water leakage.
8 Instructions for use