Care And Maintenance - Perel ABJT Série Mode D'emploi

•
Continue pumping handle until the vehicle is raised to the desired height.
Immediately support the vehicle by a pair of jack stands (not incl.). Never work
under a vehicle that is only supported by the floor jack!
•
When jack stands are in place, lower the floor jack slightly (see instructions below)
until the vehicle rests on the jack stands.
To Lower the Vehicle
•
Remove the handle from the socket and use the open end of the lower handlebar to
turn the release valve slowly counterclockwise.
Note:
•
For storage, close the release valve by turning it completely clockwise.
6.

Care and Maintenance

•
When the jack is not in use or for storage, lower the saddle completely to prevent
corrosion. Always store the floor jack in an upright position to avoid oil leakage.
•
Keep the jack clean and keep all moving parts well lubricated. Remove excessive
grease and dirt from the outside.
•
To check oil level, lower the saddle completely and open the oil filler plug. Oil level
must be just below the filler hole. Add oil when oil level is too low.
Recommended oil:
•
The oil should be replaced once a year. To replace the oil, open the oil filler plug and
remove the release valve completely by turning it counterclockwise. Be careful not
to contaminate the inside of the hydraulic system! Remove and refill via the oil filler
plug hole.
Note:
•
Close the filler hole with the oil filler plug.
•
Re-install and close the release valve completely.
•
Pull the saddle all the way up than open the release valve to lower the saddle. Force
the saddle to lower faster. Close the release valve and repeat this procedure a
couple of times to ensure proper oil distribution.
V. 02 – 15/09/2020
When the vehicle is on jack stands, first lift the vehicle until the jack stands
o
can easily be removed.
Ambient temperature -5 to +45 °C: machine oil N15
o
Ambient temperature -20 to -5 °C: synthetic spindle oil
o
Use of improper oil or other fluid can cause serious damage to the internal
o
parts of the jack!
Take appropriate safety measurements when handling oil.
o
Dispose of used oil in accordance with local regulations.
o
ABJxT
6 ©Velleman nv