Perel ABJT Série Mode D'emploi page 5

5. Installation
Before Use
•
It is possible that during shipment of the device air gets trapped inside the hydraulic
system causing malfunctioning. Turn the release valve 1 turn counterclockwise and
push the saddle all the way down.
Note:
•
Place the pump body upright and remove the oil filler plug.
•
Mount the handle: insert the upper handlebar in the middle handlebar and make
sure the spring snaps into place. Insert the lower handlebar into the middle
handlebar and again make sure the spring snaps into place. The handle is now
ready.
•
Insert the lower handlebar end of the handle into the socket.
•
Quickly pump 6-8 full strokes to remove air in the system.
•
Close the oil filler plug.
Note:
To Raise a Vehicle
•
Turn the release valve clockwise until it is closed tightly.
•
Place the vehicle in gear (or in Park (P) for vehicles with automatic transmission)
and chock the wheels that remain in contact with the floor in both directions.
•
Locate the lift points of the vehicle (refer to the vehicles' owner's manual) and make
sure they are compatible with the saddle of the jack. Do not use the jack if saddle
and lift points are not compatible to avoid structural damage to vehicle and/or jack.
Note:
•
Insert the handle into the socket and pump until the jack is almost touching the lift
point. Verify that the saddle is centred and good contact with the lift point is
assured.
Note:
V. 02 – 15/09/2020
Always comply with the safety instructions.
The open end of the lower handlebar can be used to turn the release valve.
o
The overload valve is calibrated to the maximum load. Never adjust this
o
overload valve.
Always centre the load on the saddle to avoid damage to the jack.
o
The saddle can be raised about 6 cm by turning it counterclockwise.
o
ABJxT
WARNING
5 ©Velleman nv