Quick Start - ION OMNI SCAN Guide D'utilisation Simplifié

QUICKSTART
1. Connect OMNI SCAN to your computer's USB port or to a power outlet
with the included power adapter.
2. Turn on the OMNI SCAN with the POWER button.
3. Press ENTER to select Capture Mode.
4. Insert your SD card (not included) with the label facing down into the SD
CARD SLOT. When you save your scanned images, they will be stored
on the SD card. If you do not have an SD card, you can save scanned
images to the device's internal memory (16 MB).
5. Insert your appropriate holder and film.
a. If you are scanning a slide, insert it into the FILM HOLDER SLOT
on the top of the device.
b. If you are scanning a strip of negatives, insert the included strip film
guide into the FILM HOLDER SLOT on the top of the device. Then
insert one end of the negative strip into the FILM HOLDER SLOT
on the right side of the device. Turn the FILM FEEDER WHEEL
counterclockwise while gently "feeding" the negative into the slot.
(If you want to go back to a previous frame or if the negative strip is
getting jammed, turn the FILM FEEDER WHEEL clockwise while
gently pulling the negative from the slot.)
Note: The negative strip itself must be at least three frames long.
Otherwise, it may get stuck in the device.
becomes jammed in the device, you can loosen it by inserting the
included film retrieval strip into the FILM HOLDER SLOT.
c. If you are scanning a single negative frame, insert it into the included single frame holder and
insert it into the FILM HOLDER SLOT on the top of the device.
6. The current image will be shown on the display. Before capturing your image, you can:
a. re-orient it by pressing the UP/MIRROR or DOWN/FLIP buttons
b. toggle through three different color settings (color, negative, and black/white) by pressing the
ENTER button
7. Capture your image by pressing the SCAN/HOME button. A "disk" icon will appear to confirm the image
is being saved.
If a negative strip
4