LEGRAND Wattstopper EOPC-100 Instructions D'installation page 5

Mounting to solid wall:
The EOPC-100 can be mounted to a solid wall using the paper
template that is provided.
1. Use the paper template to mark the surface of the wall with
appropriate hole spacings.
2. Drill holes in wall.
3. Use two machine screws (included) to mount the EOPC-100
to the surface. Line up screws to markings on surface.
4. Align the sensor so that the mounting screws on the wall
match the key holes on the sensor's rear housing and
secure.
Use Paper
Template to
mark surface
of wall.
EOPC-100 Sensor
Does the system work more reliably at close range (without obstructions)?
Consider Factors Affecting the Environment:
In an indoor environment, the wireless controls have a typical range of 30-150 feet. If there are obstructions and/or noise interference
the range will be less than the typical range.
Obstructions:
The range can be reduced by metal objects (metal decreases the effectiveness of RF transmission).
• Identify nearby metal, concrete and other objects possibly affecting signal strength
• If possible, try relocating the device (even slightly) away from obstructions to improve the system performance.
Does the system work better at certain times of the day?
• Look for pieces of equipment that may affect wireless performance when they are ON
• Noise interference can be either line noise (from motors) or Radio Frequency (RF)
Sensor does not learn:
• Please charge for 10 minutes in indoor light or sunlight before attempting to use, or insert optional battery
Sensor does not communicate to receiver:
• Check pairing of the sensor after install and commissioning, press test button to test the range (WITH A CHARGED SENSOR) if
the load toggles, the range is good. If the load does not toggle, pull the sensor off the ceiling, verify charge by seeing the LED on
the SENSOR flash, then press test button to test with the device close to the receiver, if still no load toggle, the device is either not
charged or has not been paired properly (or may have even been unlearned) (see pairing section above)
If device still doesn't respond:
• Make sure the sensor is paired to the receiver by placing the receiver into pairing mode then tapping once on the sensor's pairing
button.
• If the above steps do not resolve the problem call technical support at: 800.879.8585.
SENSOR MOUNTING (CONTINUED)
Mounting to metal surfaces:
Use the super-magnet on the reversable mounting disc (included)
to mount to any metal surface such as fixtures or metal desks.
Line up screws
to markings
on surface and
drill holes in wall.
TROUBLESHOOTING
5
1. Use the pull tab to release the mounting disc.
2. Snap the mounting disc onto insert on back of sensor,
magnet end face up.
3. Simply snap the sensor onto the surface.
Mounting disc
EOPC-100
Snap mounting disc
to mounting insert on
back of sensor, magnet
end face up. Snap magnet
to surface.