Domo DO7263 Mode D'emploi page 38

DO7263-64-65S
the filter before placing the dust bag into the dust bag
compartment.
5. slide a new dust bag (3.5l) in the dust bag frame.
6. close the dust bag compartment and push the lid back
into place. the spring on the dust bag frame will make
sure that the opening of the dust bag is pushed into the
right position when closing the lid.
Cleaning the air filter or HEPA filter
The exhaust air filter or HEPA filter cleans the air a final time before it leaves the
vacuum cleaner. This filter and the grid that covers the filter should be cleaned
regularly. You can clean the filter as follows:
1. turn off and unplug the vacuum cleaner. always pull
the plug itself, never pull the cord.
2. Open the grid that covers the filter by lifting up the two
clips on the grid, one by one. The filter is visible when
the grid is removed.
3. Take out the filter.
4. Rinse the filter under cold water and let it dry completely.
5. Put the filter back into place or replace the filter by a new
one. Make sure that the filter is placed properly.
6. seal with the grid. make sure that the grid clicks into
place.
38
4