Publicité
Les langues disponibles
Les langues disponibles
>
Introduction:
Congratulations on the purchase of your new MI-6 Pinpointer, made in France by XP Metal Detectors. The MI-6 pinpointer has many
innovative features so this manual requires careful reading. Note: The MI-6 can operate alone with its 6 user programs, 3 levels of sensitivity and selectable
audio modes, but it offers the advantage of being able to connect via radio link to the DEUS by selecting program N°7. For more information please refer to
the Deus V4 manual available from our web site www.xpmetaldetectors.com
>
Switch on:
Press the button while remaining away from any metal source until the end of the melody, now the MI-6 is calibrated and ready to detect.
Switch off:
Press the button for a minimum of 0.5s and then release. - Once off, the MI-6 LED flashes briefly every 4 seconds.
Note: Auto-switch off is activated after 5 min without any key press.
>
Retune:
When operating, you can re-calibrate the MI-6 by briefly pressing the button while away from any metallic source. On mineralized ground and
salt water, it is advised to re-calibrate while in contact with the ground. To obtain a precise target location, re-calibrate near to the object, the detection zone will
now be reduced.
>
Programs:
When the MI-6 is switched on for the first time, it will start in program N°2. When it is switched on again, it will start on the last program used.
To change a program: MI-6 on, press the button for 5 seconds, a short melody will indicate that you have entered the program selection mode, press again for the
desired program number. (e.g : press 7 times for program 7). After 2 seconds a melody indicates the MI-6 has returned to search mode.
Programs
1
2
3
4
5
6
Vibrate
ON
ON
ON
ON
ON
ON
Buzzer
ON
ON
ON
OFF
OFF
OFF
Sensitivity
LOW
MEDIUM
HIGH
LOW
MEDIUM
HIGH
>
Pairing the MI-6 with the DEUS
1) From the remote control menu select : OPTION > PINPOINTER > PAIRING
2) Switch on while holding down the MI-6 button for 8 seconds, this will enable pairing.
3) The MI-6 automatically selects program 7 and works with the DEUS. If you want to use the MI-6 without the DEUS radio link connection, select programs
1 to 6 on the MI-6 button menu.
MI-6 specifications and advantages when paired with the DEUS:
Audio signal transmitted to the DEUS (XP patent) / Anti-interference system (XP patent): The DEUS is automatically switched OFF when the MI-6 is in use
and then wakes up when the Mi-6 is turned OFF - When the Pinpointer is switched ON a dedicated Deus menu is activated allowing further adjustments :
/ 50 levels of sensitivity / Sound mode selection - Pitch or Pulse / Audio Tone adjustment. Other Deus features include a Target zoom screen / MI- 6 on
screen Battery level display / Long battery life of up to 90 hours / Remote recovery mode (even when the lost MI-6 is switched OFF)
>
Advanced Mode:
Switch on while keeping the button depressed for 3 seconds until you hear the melody, release the button and:
Press once
Audio PITCH or PULSE
Increase the battery life by deactivating the LED
Audio PITCH: The sound varies in tone and inten-
on all programs. When the LED is switched off,
sity, it offers a more precise target location.
the start up flashes will remain.
Audio PULSE: Higher sound, for noisy environments.
Target location is not as precise as PITCH mode.
PULSE has the same performance as PITCH mode.
>
Battery:
Unscrew the cap, connect the supplied cable to the MI-6. Use a power supply with a USB output (eg DEUS, PC, smartphones ...).
Charge time ± 3 hours / During charging the LED will flash 3 times / End of charging the LED 4 sec ON, 4 sec OFF (cycle)
Every time the MI-6 is switched on it indicates the battery level by successive flashes of the LED.
Battery life : To obtain the longest battery life (90 hours) use the MI-6 with the DEUS (prog 7) and the LED / OFF in the advanced menu.
VIBRATE
AUDIO
AUDIO + VIBRATE
Battery life
30 h
30 h
Note: Do not leave your MI-6 fully discharged for several months. With correct care your battery will last more than 5 years.
USER MANUAL
Prog 7 is intended for use with the DEUS only. It will not generate any
7 (DEUS)
sound or vibration. It is necessary to pair the MI-6 with your DEUS
OFF
For precise target location a lower sensitivity level is reccomended
OFF
prog 1 or 2. - Prog 3 uses a higher sensitivity level and is intended for
ADJUSTABLE VIA DEUS
cache searching in walls, furniture, or in mineralized soils.
Press twice
Press 3 times
LED ON or OFF
VIBRATION ON or OFF
The first 3 programs have vibration on: You can
increase the battery life by 50% by deactivating
the vibration for programs 1, 2 and 3, so that only
the audio remains.
LED + VIBRATE LED + AUDIO + VIBRATE
PROGRAM 7
20 h
11 h
10 h
>
Basic features:
All round 360 °
LED
detection
ON / OFF
More features
Audio output
Advanced settings
to the DEUS
via DEUS remote
control
Battery indication by
Battery life 90H
LED and
via DEUS
via DEUS
>
Technical features and specifications:
Radio Freq: 2.4 GHz / P: ~ 0.56mW
Detecting frequency : 12 kHz
Sensitivity: 3 levels + Retune
Led / Vibration / Audio: ON / OFF
Search for lost pinpointer
Audio mode: PULSE or PITCH
Holster / Lanyard / Charging Cable
Waterproof: 6 meters
L: 24 cm - D: 3.8cm - Weight: 170 gr
Lithium Polymer Battery
T ° of use: - 5 to 50 ° C
T ° permitted under load: 0 to 40 ° C
Patents: Pending
>
2 year limited Warranty, parts and labour:
The warranty does not cover: Damage caused by accidental breakage, fall or shock / The
manipulation of the electronic circuit by an unauthorized person / Circuitry corrosion due
to negligence, such as bad maintenance and - or replacement of used seals... / Reduced
battery life / Breaking of the lanyard cable and clips / Wear of the Holster, the case and
its rubber grip.
In the event of a breakdown contact your dealer. If the device is returned, it must be accom-
panied by the original invoice and an explanatory note. In the event that the product has
been replaced, the warranty will continue to apply as if it were the original.
>
Precaution ( Battery & Charger )
- Recharge only with a SELV power source, limited power source.
- Permissible ambient temperature under load: 0 ° C to + 40 °. Recommended storage temperature: 25 ° C
- The batteries are protected against overloads and deep discharges. Do not intervene or
short-circuit the batteries, this will destroy the protection circuits or cause smoke and fire.
- Do not leave batteries charged unnecessarily and as a precaution unplug the power
after a charge cycle.
- If you notice a perforation, odor or something abnormal drop it into a specific collection
point. Do not attempt to recharge the battery, as this may result in overheating or fire.
- Do not throw the lithium battery into the garbage, put it in a suitable collection point.
- Do not place the batteries near heat sources and do not throw them into a fire.
- Do not pierce the battery casing or attempt to solder the battery.
- There is a risk of explosion or fire if the battery is replaced by an incorrect battery.
- Only use LiPo batteries from XP (ref: D088).
- The recommended temperature range is -5 ° C to + 45 ° C.
- If you notice abnormal overheating, disconnect the power supply and do not attempt to recharge.
- Do not carry a faulty or doubtful battery by air.
90 h
Access all functions
Loudspeaker &
3 levels of
Fast re-tune
with
Vibration
sensitivity
1 single button
ON / OFF
Anti-interference
7 programs
2 audio modes
Waterproof
System
PITCH or PULSE
up to 6 meters
Warranty 2 years
Recover
Target
Rubber
lost MI-6
zoom screen
ergonomic
via the DEUS
>
Declaration of conformity EU
This declaration is established under the responsibility of the manufacturer:
XPLORER SARL - 8 rue du Développement - F-31320 CASTANET-TOLOSAN
We, XPLORER, certify that this detector complies with the essential requirements of the
European R & TTE Directive 1999/5 / EC, which aims to approximate the laws of the
Member States concerning the use of radio spectrum, electrical radio compatibility and
electrical safety. The conformity assessment of the device was carried out in accordance
with the essential requirements of this Directive and the harmonized standards:
SECURITY (Article 3.1.a): EN60950-1: 2001 + A11, EN50366: 2003 and EN50371: 2002
EMC (art 3.1.b): EN301489-3: V1.4.1, EN61326-1: 1997 + A1 + A2 + A3, EN55011: 2007
RADIO SPECTRUM (Art 3. 2): EN300440-1: V1.3.1, EN300440-2: V1.1.2
XPLORER SARL - 8 rue du Développement - F-31320 CASTANET-TOLOSAN
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO
THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
This symbol on the product or its packaging means that this product should not
be disposed of with your household waste. You must bring it to a collection point
provided for the recycling of electrical and electronic waste. This selective sorting
and associated recycling makes it possible to preserve natural resources and
to avoid potential risks to human health and the environment, which could result from
inappropriate disposal due to the presence of dangerous substances in the equipment
Electrical and electronic. For more information on where to store your electrical waste,
please contact the store where you purchased this product or return it to your supplier.
Xplorer reserves the right to change specification or specifications of its detectors without
FCC ID : XFJA01 IC: 8392A - A01
prior notice.
MODEL : MI61
This document contains information that is protected by copyright, trademark, and copy-
MADE IN FRANCE
right laws. No part of this document may be reproduced, logos or trademarks.
Adjust the audio
50 levels of
Battery Lithium
tone
Sensitivity
rechargeable
via the DEUS
via the DEUS
Parts totally
Rotating XP
Lanyard with
interchangeable
holster
stainless rings
OTHER: EN300330-1: V1.5.1 on September 10, 2009.
A copy of the certificate may be provided upon request from:
© 2016 Xplorer sarl.
Publicité
