Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY Step 3
eX-78 SHoWn
all
MoDelS
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
MAIN FRAME
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
CRANK
PEDAL ARM
GUIDE RAIL
PEDAL ARM WHEEL
12
EX-58-EX-78-GS1050E-CE5.1-OM-rev1.5.indd 12-13
HarDWare BaG 3 CONTENTS :
WAVY WASHER (L)
BOLT (M)
SPRING WASHER (B)
22.5 mm
20 mm
15 mm
Qty: 2
Qty: 2
Qty: 2
Open hardware bag 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
C
gently slide the console mast onto the
main frame and attach console mast to
main frame using pre-installed bolts.
Slide wavy washer (l) over crank
D
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
Attach the pedal arm to the crank using 1
E
flat washer (k), 1 spring washer (b)
and 1 bolt (m).
WAVY WASHER (L)
FLAT WASHER (K)
Repeat steps E–F on the opposite side of the
F
SPRING WASHER (B)
elliptical.
BOLT (M)
ASSEMBLY Step 4
eX-78 SHoWn
FLAT WASHER (K)
20 mm
Qty: 2
LOWER HANDLEBAR
HarDWare BaG 4 CONTENTS :
WAVY WASHER (L)
22.5 mm
Qty: 2
CONSOLE MAST
FLAT WASHERS (N)
FLAT WASHERS (K)
Open hardware bag 4.
A
BOLT (M)
Silde 1 flat washer (n), 1 wavy washer
B
(l) and another flat washer (n) onto the
console mast.
Slide lower handlebar onto console
C
mast and attach using 1 flat washer (n),
HANDLEBAR
CAP
1 flat washer (k), 1 handlebar cap, 1
SPRING
WAVY WASHER (L)
WASHER (B)
spring washer (b) and 1 bolt (m).
Repeat steps B–C on the opposite side of the
D
elliptical.
all
BOLT (M)
SPRING WASHER (B)
20 mm
15 mm
MoDelS
Qty: 2
Qty: 2
FLAT WASHER (N)
FLAT WASHER (K)
25 mm
20 mm
Qty: 6
Qty: 4
13
8/17/09 8:07 AM
Publicité
Table des Matières
