Troubleshooting; Checkpoints - Samsung WA54M8750A Manuel Utilisateur

Troubleshooting

Checkpoints

If you encounter a problem with the washer, first check the table below and try the
suggestions.
Problem
Does not turn on.
Does not start.
Water is not supplied.
After a cycle, detergent
remains in the
automatic dispenser.
56 English
WA8700M_WA54M8750A_DC68-03774B-02_EN.indd 56
• Make sure your home electrical system is providing electrical
power that matches the requirements of the washer. See page 19.
• Make sure the power cord is completely plugged in.
• Check the fuse or reset the circuit breaker.
• Make sure the door is closed.
• Make sure the water taps are open.
• Make sure to press or tap START/PAUSE to start the washing
machine.
• Make sure Child Lock is not activated.
Before the washing machine starts to fill, it will make a series of
•
clicking noises to check the door lock, and then does a quick drain.
• Was the door opened during the spinning cycle? Close the door,
and then press or tap START/PAUSE to resume.
• The machine enters Standby or is in a soaking cycle. Please wait.
• Check the fuse or reset the circuit breaker
• Make sure you press or tap START/PAUSE after selecting the cycle
and options.
• Make sure the water taps are open.
• Are the mesh filters in the water inlets clogged? Clean the mesh
filters by brushing with a toothbrush. See page 53.
• Is the water supply cut off? If the water supply is cut off, close the
tap and power off.
• Straighten the water supply hoses.
• Open and close the door, and then press or tap START/PAUSE.
If the water pressure is low, it takes longer to start washing.
•
• If the water level is not as high as necessary or lower than
expected, use the level selector to adjust the water level.
• Make sure the washing machine is running with sufficient water
pressure.
• Make sure the detergent drawer is properly inserted.
• Remove and clean the detergent drawer, and then try again.
Action
2017-04-18 9:59:52