emerio UVC-121220.15 Mode D'emploi page 7

6. After use, press the on/off button to turn off the appliance.
NOTE: During use, please pay attention to the dust capacity and empty the dust cup before the MAX-level
indication is reached. This appliance is for dry suction only.
Caution: The suction hole opening must be open and free of any obstructions at all times. Otherwise, the motor
will overheat and could become damaged.
RECHARGING THE APPLIANCE:
1. When there is only one pilot light blinking in the process of operation, the appliance needs to be recharged.
2. Insert the connector pin into the charger hole (C) of the appliance, and then plug the charger into the power
socket. The appliance is in charge.
3. While charging, the pilot light will be blinking to indicate the charger is under working. When the charging
operation is finished, the charger will switch off automatically and 4 pilot lights will be on instead of blinking.
4. After charging, unplug the charger first, and then remove the connector pin.
Note:
(1) Do not let the appliance uncharged for a long time, because the inner accumulators may be damaged.
(2) The appliance cannot work during charging.
CLEANING AND MAINTENANCE
1. Except for the main unit and battery, other parts can be cleaned in warm soapy water (<40℃). Rinse and
dry them completely before reassembly. Do not immerse the main unit in water or any other liquids.
2. Use only a soft moist cloth to clean the outside of the main unit. Do not allow any kind of liquid to enter the
main unit.
3. Do not use aggressive chemicals or abrasives.
4. Do not use the device if the filter is broken or worn out.
5. The unit does not contain parts serviceable by you, do not disassemble it and do not try to repair it yourself.
6. Mount the bracket onto the wall, the appliance can be rested on the bracket after use.
1. How to empty the dust cup:
1) Turn off the appliance. Press the dust cup release button to take out the dust cup.
2) Take out the cyclone.
3) Empty the dust cup.
2. How to clean the dust cup filter:
1) Note the "lock" and "unlock" logos on the top of the HEPA filter, switch it as arrow points to take the HEPA
filter out from the cyclone.
2) Rinse them in water, and then air dry completely before placing them back in the dust cup.
- 6 -