Keter PRO Série Guide D'utilisation page 5

OPERATION: CLOSING THE WORKBENCH
1. Fold the centre support section down and push in on the side supports to unlock them (figure F)
2. Reach through the openings in the table top and grasp the lower section of the bench. Pull up
on the lower section to begin collapsing the legs. (figure G)
3. Lower the unit to the ground as shown in figure H.
4. Once the unit is flat on the ground, press down on the table top to place the unit into its fully
closed position as shown in figure I.
F
H
ADJUSTABLE CLAMPS
The two adjustable clamps can be used in both a vertical and horizontal mode. The long channels in
the table top allow the clamps to be anchored in a stationary horizontal position. The shorter slots in
the table top allow for the clamps to be used in a vertical position (figure J). J1 through J6 illustrate
how to use the clamps in both horizontal and vertical modes.
G
I
J
3