Using On Ac House Current; Before Playback - Aiwa XP-SP910 Mode D'emploi

Table des Matières

Publicité

3
D
HOLD
RESUME
OFF
E
F
G
1
3
DC 5~6 V
STOP
OFF/CHARGE
STOP
OFF/CHARGE
PLAY/
DSL
VOLUME
PHONES/
LINE OUT
2
H
use.
• When using on rechargeable batteries for the first time, charge them until the
battery indicator goes out.
• Before charging the batteries, close the disc compartment. You cannot charge
the batteries while it is opened.
1 Insert the rechargeable batteries with the 0 and 9 marks correctly aligned.
2 Connect the AC adaptor.
Pull out the rubber cap before connecting the adaptor.
1 to DC 5 ~ 6 V jack
2 to wall outlet
3 Keep sSTOP/OFF/CHARGE pressed for about 1 second to start charging.
"Con" is displayed and the battery indicator blinks.
After charging, disconnect the AC adaptor.
Time to recharge the batteries
Recharge the batteries when
lights, "LobAtt" is displayed and the current operation will stop.
To stop charging
Press sSTOP/OFF/CHARGE during charging.
ATTENTION:
The product you have purchased can be powered by
nickel cadmium batteries which are recyclable. At the
end of their useful life, under various state and local laws,
it is illegal to dispose of these batteries into your municipal
waste stream.
PAUSE
Please call 1-800-289-2492 for information on how to
recycle these batteries.

USING ON AC HOUSE CURRENT

Connect the supplied AC adaptor in the same way as when recharging the batteries.
During operation on AC house current, all of the battery indicators disappear.

BEFORE PLAYBACK

HOLD switch → D
Release the HOLD switch before playback. → a
When not using the unit, set the HOLD switch to the HOLD position. Accidentally
pressed button will not function. → b
If buttons are pressed when the HOLD switch is set to the HOLD position, "HOLd"
flashes in the display.
Turning on and off → D
Turning the power on
Press e PLAY/PAUSE. Power is turned on and playback starts.
Note
"Err" appears on the display in the following cases:
– When you try to play the unit without a disc in the disc compartment.
– When you play a disc placed upside-down or a defective disc.
Turning the power off
If no new operations are done within 30 seconds from the end of last operation,
the power is turned off automatically. (Auto power off function)
• You can turn off the power before it is automatically turned off by pressing sSTOP/
OFF/CHARGE.
Standby mode → D
When an operation finishes, the unit goes into standby mode until the auto power
off function automatically turns off the power.
To enter standby mode, press e PLAY/PAUSE to start playback, then press
sSTOP/OFF/CHARGE.
Adjusting the sound → E
Volume
Press + to increase the volume.
Press - to decrease the volume.
DSL
Press DSL for more powerful sound and deeper bass.
: Deep bass is emphasized.
: Deep bass is strongly emphasized.
: Normal sound
Connecting the headphones → F
Pull out the rubber cap and connect the supplied headphones to the PHONES/
LINE OUT jack.
Inserting a disc → G
1 Set the dial to the OPEN position to open the disc compartment.
2 Place a disc in the center with the label side facing up.
3 Close the disc compartment tightly and set the dial to the LOCK position.
To remove the disc → H
Pick up the disc, holding its edge, while pressing the pivot gently.
Note
• The unit may not play a CD-R/RW disc that is recorded on personal computers
or some kinds of CD-R/RW recorders because of differences in recording
platforms.
• Do not attach any seal or label to either side (the recordable side or the labeled
side) of a CD-R/RW disc. It may cause malfunction.
lights. If the unit remains in use after

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Xp-sp911

Table des Matières